EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
KHACHIMO
A 30 unit ATX power supply tested working for Mitsubishi elevator power boards
The RMC30-1 is a dedicated ATX power board designed for Mitsubishi elevator systems. It supplies the 30 volt rail required by the original equipment and is sold as a tested, working unit. This component targets maintenance teams and technicians who need a direct replacement for a failed elevator power board. It is not intended for standard PC builds or general ATX applications.
Each board is verified as functional before shipment and built to good quality standards for reliable service. The ATX form factor allows it to fit the existing mounting points inside the elevator controller cabinet. Installers can swap the board without modifying wiring or chassis layout. Buyers requiring a different voltage output or a board for non-Mitsubishi systems should source an alternative part.
| Type | ATX |
|---|
The ATX form factor defines the physical mounting pattern and standard connector set used in compatible chassis.
It uses the standard ATX mounting hole pattern and rear cut-out dimensions for installation in a matching enclosure.
이 진열대의 다른 상품
같은 진열대, 같은 체크아웃 — 코인 8종, 환율 잠금 30분.
결제할 코인과 가격을 확인할 통화입니다.
체크아웃 시 지갑에서 전송됩니다.
표시 전용 — 카탈로그 가격은 달러 기준입니다.
일치하는 통화가 없습니다.
사이트에서 사용할 언어를 선택하십시오.
일치하는 언어가 없습니다.
처음 방문하셨나요?
이미 계정이 있으신가요?
자동 재설정 기능은 없습니다. 이 쇼핑몰은 어떠한 메일도 보내지 않으므로 요청할 일회용 링크 자체가 없습니다. 계정에 등록된 이메일 주소를 그대로 두시면 담당자가 직접 확인해 처리합니다.
요청 접수
받은편지함으로 오는 것은 아무것도 없습니다 — 이 쇼핑몰은 메일을 전혀 보내지 않습니다. 담당자가 직접 확인해 처리합니다.
기억나셨나요?