저희는 암호화폐로 결제를 받습니다 — 보유하신 코인으로 실제 하드웨어를 구매하실 수 있습니다.암호화폐로 결제하고, 실제 하드웨어 구매에 사용하십시오. 전 세계 어디서나 US$399 이상 구매 시 무료 보험 배송. 무지 상자에 담아 독일에서 발송합니다.US$399 이상 구매 시 무료 보험 배송. 체크아웃을 시작하면 30분 동안 환율이 잠깁니다.30분간 환율 잠금. 모든 제품은 밀봉된 상태로 일련번호를 확인한 후 24개월 보증을 제공합니다.밀봉 포장, 24개월 보증.

가격 추적 로그인
Compact black network injector with power cord and status lights

STARTECH

STARTECH 1-Port 10Gbps PoE++ Injector 90W

SKU CH-3G77-G5CEQ

Delivers up to 90 W of PoE++ power over a single 10 Gbps port for access points, IP cameras, VoIP phones, IPTV or access controls

  • Delivers up to 90W over a single cable
  • Supports 10Gbps data rates for high-speed networks
  • Includes 1.8m power cord for flexible placement
  • Powers access points, IP cameras and VoIP phones
  • Quick-start guide simplifies initial setup

Single-port 10Gbps PoE++ injector

This single-port injector supplies up to 90W of PoE++ power over a 10Gbps Ethernet link, removing the need for separate power cabling to compatible devices. It targets installers deploying access points, IP cameras, VoIP phones, IPTV endpoints or access-control readers where high-speed data and high-power delivery must share one cable run.

Thermal and power profile

The unit operates from an included 1.8m mains cord and delivers its full 90W budget without requiring active cooling, so it runs silently in typical indoor deployments. Power draw scales with the attached load rather than idling at the maximum rating, keeping heat output low in normal use.

Included accessories

A 1.8m power cord and a quick-start guide ship in the box, allowing immediate installation without sourcing a separate IEC lead or hunting for setup instructions. The guide covers the basic wiring steps for the supported device classes listed above.

주요 특징

  • Delivers up to 90W over a single cable
  • Supports 10Gbps data rates for high-speed networks
  • Includes 1.8m power cord for flexible placement
  • Powers access points, IP cameras and VoIP phones
  • Quick-start guide simplifies initial setup

사양

BrandStarTech
배송 무게0.54 kg
포장 크기216 × 124 × 51 mm

이 상품에 대한 질문

How do I install the 10Gbps PoE++ injector and what step is often missed?

Connect the injector between your network switch and the powered device using a single Ethernet cable; the step often missed is verifying the device accepts 90W PoE++ before powering on.

What maintenance or replacement will the injector need over time?

The included 1.8m power cord is the only user-serviceable part; replace it if the plug or cable shows wear, otherwise the injector itself has no moving parts to service.

What limit appears first when the injector runs continuously at full load?

The 90W power budget is the first constraint; sustained loads above that will cause the injector to shut down or limit power to protect connected equipment.

이 진열대의 다른 상품

고객들이 함께 비교한 상품

같은 진열대, 같은 체크아웃 — 코인 8종, 환율 잠금 30분.