LONGER
LONGER Laser Engraver Enclosure with Vent 27.5 x 27.5 x 13 inches
- Laser Engraver
US$69.99
0.00088832BTC
재고 있음
VEVOR
VEVOR SH-350 50W CO2 Laser Engraver 20 x 12 in
A 50 W CO₂ laser engraver with a 20 x 12 in work area and 600 mm/s engraving speed
- TypeOther Appliances
- 50 W CO₂ tube cuts wood, acrylic and glass
- 600 mm/s engraving speed finishes jobs quickly
- 20 × 12 in work area fits large panels
- 18 mm focal length gives sharp detail on every pass
- galvanized-steel frame keeps the machine rigid during long runs
VEVOR SH-350 50W CO2 Laser Engraver
The VEVOR SH-350 is a 50W CO2 laser engraver with a 20 x 12 in work area. It delivers an engraving speed of 600 mm/s and uses an 18 mm focal length for processing wood, acrylic and glass. The machine frame is built from galvanized steel and ships with a water pump, power cable, focusing scale, key switch, accessory kit and user manual.
Who this suits and who should look elsewhere
Makers and small workshops needing a mid-power CO2 system for cutting and engraving flat sheet materials will find the 50W tube and 600 mm/s speed practical. Buyers who need a larger bed than 20 x 12 in or higher laser power for thicker cuts should consider other options. The unit includes air assist and LightBurn, CorelDRAW and RDWorks compatibility for standard workflow integration.
Deciding specification: 50W CO2 laser power
The 50W CO2 laser tube is the single figure that determines whether this engraver matches your material thickness and throughput requirements. It defines the maximum cutting depth in wood and acrylic and sets the engraving contrast achievable on glass. If your projects demand deeper cutting or faster batch processing, a higher wattage source is required.
주요 특징
- 50 W CO₂ tube cuts wood, acrylic and glass
- 600 mm/s engraving speed finishes jobs quickly
- 20 × 12 in work area fits large panels
- 18 mm focal length gives sharp detail on every pass
- galvanized-steel frame keeps the machine rigid during long runs
사양
| Type | Other Appliances |
|---|
이 상품에 대한 질문
What are the external dimensions of the 20 x 12 in work area so I can plan bench space?
The engraving bed is 20 x 12 in; allow extra room around the galvanized-steel frame for the water pump, exhaust hose and cable routing.
Which steps in the first-time setup are most often missed?
Fit the water pump and confirm coolant flow before powering the laser tube, then set the 0.7 in focal length with the supplied focusing scale before running a test file.
Which consumables will need replacing after extended use?
The CO2 laser tube, water-pump impeller, focusing lens and air-assist filters are the items that wear out and require periodic replacement.
이 진열대의 다른 상품
고객들이 함께 비교한 상품
같은 진열대, 같은 체크아웃 — 코인 8종, 환율 잠금 30분.
