Wij accepteren cryptovaluta — zo kunnen de munten die u bezit echte hardware kopen.Betaal in crypto, besteed het aan echte hardware. Gratis verzekerde verzending wereldwijd vanaf $399. Neutrale dozen zonder merk, verzonden vanuit Duitsland.Gratis verzekerde verzending vanaf $399. Uw koers wordt 30 minuten vastgezet zodra het afrekenen begint.Koers 30 minuten vastgezet. Elk artikel is verzegeld, het serienummer wordt gecontroleerd, en het valt onder 24 maanden garantie.Verzegeld, 24 maanden garantie.

Favoriete artikelen Inloggen
Green circuit board SODIMM module with black memory chips and gold edge contacts

NEMIX RAM

NEMIX RAM 8GB DDR4 2400 CL17 1.2V 260-PIN SODIMM QNAP TVS-472XT TVS-672XT TVS-872XT memory upgrade

SKU CH-MFRD-NCEM4

8GB DDR4 2400 SODIMM for QNAP TVS-472XT, TVS-672XT and TVS-872XT NAS systems

  • Capacity8GB
  • SpeedDDR4 2400 (PC4 19200)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 8GB capacity expands NAS memory for heavier workloads
  • DDR4 2400 speed matches QNAP TVS-472XT, TVS-672XT, TVS-872XT specs
  • 2V low voltage reduces power draw and heat
  • CL17 latency supports responsive multitasking on compatible NAS
  • 260-pin SODIMM form factor fits QNAP NAS memory slots

NEMIX 8 GB DDR4 SODIMM for QNAP NAS

This 8 GB DDR4 2400 MHz SODIMM is built for QNAP TVS-472XT, TVS-672XT and TVS-872XT units. It runs at 1.2 V with CL17 latency and uses a 260-pin unbuffered non-ECC design. The module adds capacity to supported NAS appliances without requiring configuration changes.

Suits owners expanding memory in listed QNAP models

The stick is made for the three TVS-XT series NAS devices named above. It will not fit systems that need ECC, registered DIMMs, 288-pin desktop memory or a different DDR generation. Buyers with other QNAP series or non-QNAP hardware should verify their platform requirements first.

Single-module kit simplifies installation

The package contains one 8 GB SODIMM, so you can populate a single slot or add to an existing bank. No extra cables, brackets or software are included. The memory is tested for compatibility with the target NAS units, letting you upgrade by inserting the module and restarting the device.

Pluspunten

  • 8GB capacity expands NAS memory for heavier workloads
  • DDR4 2400 speed matches QNAP TVS-472XT, TVS-672XT, TVS-872XT specs
  • 2V low voltage reduces power draw and heat
  • CL17 latency supports responsive multitasking on compatible NAS
  • 260-pin SODIMM form factor fits QNAP NAS memory slots

Specificaties

BrandNEMIX RAM
SeriesQNAP NAS Compatible Series Memory
ModelQNAP DDR4 2666MHZ Non-ECC Unbuffered SODIMM NAS Memory
Part NumberMS19200-818K1
Capacity8GB
SpeedDDR4 2400 (PC4 19200)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemQnap
CAS LatencyCL17
Heat SpreaderNo
Type260-PIN DDR4 SODIMM
Rank1Rx8
FeaturesDDR4 Non-ECC Unbuffered SODIMM Motherboard Compatible
Package Content8GB (1X8GB) DDR4 2400MHZ PC4-19200 2Rx8 1.2V CL17 260-PIN Non-ECC Unbuffered SODIMM

Vragen over dit artikel

What QNAP NAS models must I already own for this 260-pin SODIMM to be compatible?

This module is validated for the QNAP TVS-472XT, TVS-672XT and TVS-872XT series.

How will the CL17 2400 MHz sticks behave if I keep my existing 2666 MHz modules installed?

The system will run all memory at the lowest common speed, so the faster modules will operate at 2400 MHz with CL17 timings.

How can I confirm the 8 GB module is recognised at 2400 MHz after installation?

Open the QNAP Control Panel, go to System > Hardware and verify the memory line shows 2400 MT/s and the correct total capacity.

Ook in deze afdeling

Klanten vergeleken ook

Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.