Zyvpee
Zyvpee DFB0612H 60x25mm 12V .15A ball bearing 2-wire case fan
A 60 × 25 mm ball-bearing case fan running on 12 V at .15 A with a two-wire power connector
- TypeCase Fan
- Bearing TypeBall
- Power Connector2 Wires
- ColorBlack
- LEDNon-LED
- FeaturesDC square Cooler
- Ball bearing reduces wear for longer service life
- 12 V 0.15 A draws little power from the PSU
- 60 x 25 mm frame fits tight 6 cm mounting points
- Two-wire power connector simplifies installation
- Non-LED black design keeps the build dark
Compact 60 mm case fan
The Zyvpee DFB0612H is a 60 mm square case fan designed for tight chassis spaces where a small DC cooler is required. It suits builders who need a basic airflow device for legacy hardware or specialised enclosures. The two-wire power connector provides simple 12 V operation without speed reporting or PWM control.
Ball bearing thermals and power
A ball bearing supports the rotor for consistent rotation and a rated current of .15 A at 12 V. The non-LED black frame runs quietly enough for office or home theatre builds while moving air through the 25 mm thick frame. Power draw stays low, making it suitable for auxiliary cooling spots.
Sustained load behaviour
Under continuous duty the ball bearing maintains stable speed without the wear-in period seen in sleeve designs. The two-wire design means voltage changes directly alter rpm, so the fan tracks system temperature linearly. It is not suited for builds that require automatic speed curves or header monitoring.
Pluspunten
- Ball bearing reduces wear for longer service life
- 12 V 0.15 A draws little power from the PSU
- 60 x 25 mm frame fits tight 6 cm mounting points
- Two-wire power connector simplifies installation
- Non-LED black design keeps the build dark
Specificaties
| Series | DFB0612H |
|---|---|
| Model | DFB0612H |
| Type | Case Fan |
| Bearing Type | Ball |
| Power Connector | 2 Wires |
| Color | Black |
| LED | Non-LED |
| Features | DC square Cooler |
| Dimensions | 60*60*25mm |
Vragen over dit artikel
How do I install this 60 x 25 mm 12 V fan using the two-wire connector?
Mount the fan in a 60 mm square cut-out with four screws, then connect the two wires to a 12 V header or molex adapter matching the .15 A draw; the step often missed is confirming polarity before powering on.
What maintenance will the ball-bearing DFB0612H need over time?
Ball bearings are sealed, so no lubrication is required; if noise or vibration appears after extended use, the entire fan is replaced rather than serviced.
At what point does the .15 A current limit become the constraint during continuous operation?
The .15 A rating is the steady-state maximum; sustained loads that push the motor beyond this draw will trigger the supply’s current limit or cause the fan to stall.
Ook in deze afdeling
Klanten vergeleken ook
Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.
ModMyMods
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear
US$ 0,82
0.00001045BTC
Op voorraad