BFKK
BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
214,99 USD
0.00277675BTC
Dostępny
A-Tech
A-Tech 4GB DDR3L 1600 SODIMM laptop RAM Micron MT16KTF51264HZ-1G6 K1 M1 PC3L-12800 2Rx8
A 4 GB DDR3L 1600 SODIMM module that replaces Micron MT16KTF51264HZ-1G6 parts and runs at 1.35 V for laptop upgrades
- Capacity4GB
- Type204-Pin DDR3 SO-DIMM
- SpeedDDR3L 1600 (PC3L 12800)
- CAS LatencyCL11
- Voltage1.35V
- ECCNo
- 4GB capacity expands multitasking headroom for everyday workloads
- DDR3L 1600 speed accelerates data throughput to 12800 MB/s
- 35V low-voltage operation reduces power draw and heat
- 204-pin SODIMM form factor fits standard laptop memory slots
- Tested compatible replacement for Micron MT16KTF51264HZ-1G6 series
4GB DDR3L 1600 SO-DIMM for notebooks
This A-Tech module provides a single 4GB stick of DDR3L memory rated at 1600MHz with a low 1.35V operating voltage. It uses the standard 204-pin SO-DIMM form factor and carries CL11 latency timings for broad laptop compatibility. The unbuffered, non-ECC design suits mainstream consumer notebooks and all-in-one systems needing a straightforward capacity increase.
Best for DDR3L laptop owners adding capacity
Buyers with notebooks that accept DDR3L SO-DIMMs at 1.35V will find this a direct fit for the listed Micron part numbers. Systems requiring ECC registered modules, higher-density sticks, or different voltage standards cannot use this module. It is also unsuitable for desktops needing full-size DIMMs or platforms limited to older DDR3 1.5V operation only.
204-pin DDR3L SO-DIMM interface decides fit
The module installs only in slots keyed for 204-pin DDR3L SO-DIMMs running at 1.35V. Verify your laptop's manual or the original Micron MT16KTF51264HZ-1G6 sticker to confirm this exact pin count, voltage, and DDR3L signalling before ordering.
Najważniejsze cechy
- 4GB capacity expands multitasking headroom for everyday workloads
- DDR3L 1600 speed accelerates data throughput to 12800 MB/s
- 35V low-voltage operation reduces power draw and heat
- 204-pin SODIMM form factor fits standard laptop memory slots
- Tested compatible replacement for Micron MT16KTF51264HZ-1G6 series
Specyfikacja
| Brand | A-Tech |
|---|---|
| Capacity | 4GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Recommend Use | AMD & Intel Compatible |
Pytania dotyczące tego produktu
Will this 204-pin DDR3L SODIMM fit my laptop's memory slot?
Yes, the module uses the standard 204-pin SO-DIMM form factor used by most DDR3 laptop slots.
What is the correct way to seat the module so it locks in place?
Align the notch with the slot key, insert at an angle, then press down firmly until both side clips click.
Does this 1.35V DDR3L module need any special cooling or replacement schedule?
No, standard laptop airflow is sufficient and the memory has no moving parts to wear out.
Także w tym dziale
Klienci porównywali też te produkty
Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.
BFKK
BFKK 2U Micro ATX Rackmount 2×5.25" 4×3.5" Side 80mm Fan
- Rackmount
216,99 USD
0.00280258BTC
Dostępny
