DELL
DELL 400-AGTP 1.80 TB 10000 RPM SAS 2.5" internal hard drive
A 1.80 TB 10000 RPM SAS 2.5" internal hard drive, hot-swappable for compatible Dell PowerEdge servers
- NAND Flash Memory TypeHard Drive
- 80 TB capacity expands server storage
- 10000 RPM spindle speed accelerates data access
- 6Gb/s SAS interface enables fast transfers
- 5 inch hot-swappable form factor simplifies maintenance
- Compatible with Dell PowerEdge R630 R730 R730XD T630 servers
Dell 1.8 TB SAS drive for PowerEdge servers
The Dell 400-AGTP is a 1.80 TB internal hard drive spinning at 10000 RPM with a 6Gb/s SAS interface in a 2.5 inch form factor. It is built for Dell PowerEdge servers including the R630, R730, R730XD and T630 models and supports hot-swap operation.
Suited for PowerEdge storage expansion.
This drive fits administrators adding capacity to the listed PowerEdge systems where a SAS backplane and hot-swap bays are present. Buyers without a compatible Dell server chassis or a 6Gb/s SAS controller cannot install or use the drive.
6Gb/s SAS interface decides compatibility
The single specification that determines fit is the 6Gb/s SAS interface standard; the drive will only function in a system that provides this exact connection and supports the Dell-qualified firmware.
Najważniejsze cechy
- 80 TB capacity expands server storage
- 10000 RPM spindle speed accelerates data access
- 6Gb/s SAS interface enables fast transfers
- 5 inch hot-swappable form factor simplifies maintenance
- Compatible with Dell PowerEdge R630 R730 R730XD T630 servers
Specyfikacja
| Brand | Dell |
|---|---|
| NAND Flash Memory Type | Hard Drive |
Pytania dotyczące tego produktu
Does my server need a 6Gb/s SAS backplane to use this 1.80 TB drive?
Yes, the drive uses a 6Gb/s SAS interface and fits a 2.5" hot-swap bay, so the server must provide a compatible SAS backplane or controller.
Will this 10,000 RPM SAS drive work in a Dell PowerEdge R630 alongside existing 3.5" drives?
The drive is qualified for PowerEdge R630, R730, R730XD and T630 servers; it occupies a 2.5" bay, so it can coexist with 3.5" drives if the chassis has both bay types.
How can I confirm the drive is running at 10,000 RPM after installation?
Check the server BIOS or RAID controller utility — it will report the spindle speed as 10000 RPM and the link speed as 6Gb/s SAS for this 400-AGTP model.
Także w tym dziale
Klienci porównywali też te produkty
Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.
