Intel
Intel D3 S4520 1.92TB SATA 2.5" 7.0mm internal SSD
1.92 TB SATA solid-state drive in a 2.5 inch 7.0 mm form factor for internal storage
- 92 TB capacity stores large datasets
- SATA 6 Gb/s interface enables broad compatibility
- 5 inch 7.0 mm form factor fits standard bays
- 3D TLC NAND balances endurance and cost
- D3 S4520 series targets read-intensive workloads
Intel D3 S4520 1.92TB SATA SSD
The Intel D3 S4520 is a 1.92TB internal solid-state drive using a SATA 6Gb/s interface and 3D TLC NAND. It fits a standard 2.5 inch bay with a 7.0mm height. This drive serves read-intensive workloads in servers and storage arrays.
2.5 inch SATA drive for read-heavy loads
This drive suits administrators upgrading SATA-based platforms that require high capacity and consistent read performance. Builders whose systems only accept PCIe or M.2 form factors cannot install this model. Buyers needing higher write endurance should evaluate drives specified for mixed-use or write-intensive tiers.
SATA 6Gb/s interface and 1.92TB capacity
The single specification that decides fit is the SATA 6Gb/s interface combined with the 1.92TB capacity in a 2.5 inch 7.0mm form factor. The host must provide a compatible SATA port and physical bay. Capacity and interface together determine whether this drive matches the storage requirement.
Najważniejsze cechy
- 92 TB capacity stores large datasets
- SATA 6 Gb/s interface enables broad compatibility
- 5 inch 7.0 mm form factor fits standard bays
- 3D TLC NAND balances endurance and cost
- D3 S4520 series targets read-intensive workloads
Specyfikacja
Na razie brak opublikowanej specyfikacji tego produktu.
Pytania dotyczące tego produktu
How much power does the 1.92TB SATA drive draw during all-day operation?
The Intel D3 S4520 1.92TB SATA 2.5" 7.0mm internal SSD consumes minimal power typical of SATA SSDs, generating little heat and operating silently with no moving parts during continuous use.
What connection does my system need for the Intel SSDSC2KB019TZ01 to work?
Your motherboard or host adapter must provide a standard SATA 6Gb/s data port and a SATA power connector; the 2.5" 7.0mm form factor fits any 2.5" drive bay or caddy.
Will the D3 S4520 1.92TB SSD work alongside my older SATA hard drives?
Yes, it connects to the same SATA interface as legacy hard drives, so the system sees it as another SATA device and you can mix it with older drives on the same controller.
Także w tym dziale
Klienci porównywali też te produkty
Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.
