KEHIPI USB-C PD Trigger Board 10PCS 5V9V12V15V20V 100W Screw Terminal

Ten-board pack for USB-C power negotiation

This pack contains ten identical PD trigger boards that request a fixed voltage from any USB-C Power Delivery source. Each module accepts 4 V to 22 V input and can select 5 V, 9 V, 12 V, 15 V or 20 V output via a three-position dial switch. The boards are intended for makers and engineers who need repeatable voltage selection for prototypes, test fixtures or permanent installations.

Screw terminals and dial switches replace

Every board ships with screw terminals so output wires can be secured without a soldering iron. The three tiny toggle switches set the desired voltage profile in seconds, and the on-board controller handles forward or reverse USB-C insertion automatically. Over-temperature and over-voltage protection circuits are integrated, so a misconfigured charger cannot damage the module or the downstream load.

100 W maximum power through a 20 V fixed rail

The single specification that decides fit is the 100 W ceiling at 20 V. If the target device draws more than 5 A at 20 V, or requires a programmable PDO rather than the five fixed steps, these boards will not satisfy the requirement. Buyers who need adjustable voltage steps, higher current at lower voltages, or negotiation above 20 V must choose a different controller.