Lenovo
Lenovo 2 TB 3.5" 7200 RPM SATA Internal Hard Drive
A 2 TB 3.5" desktop hard drive spinning at 7200 RPM over a SATA 6.0Gb/s interface
- InterfaceSATA 6.0Gb/s
- Capacity2TB
- RPM7200 RPM
- Form Factor3.5"
- 2 TB capacity stores large media libraries
- 7200 RPM spindle speed delivers fast data access
- SATA 6.0 Gb/s interface enables high transfer rates
- 5 inch form factor fits standard desktop bays
- Designed for Lenovo ThinkServer RS160 compatibility
2 TB 7200 RPM SATA Hard Drive
The Lenovo 2 TB 3.5" internal hard drive delivers 7200 RPM spindle speed over a SATA 6.0Gb/s interface. It provides 2 TB of storage capacity in a standard 3.5-inch form factor for desktop or server installation. The drive is supplied new and uses a Near Line SATA connection.
Desktop and Server Storage Users
This drive suits builders adding bulk storage to a desktop PC or a compatible Lenovo ThinkServer RS160 where 3.5-inch bays are available. It is not for systems that only accept 2.5-inch drives or that require hot-swap capability. Buyers needing a different capacity or a solid-state drive should consider other options.
SATA 6.0Gb/s Interface
The single specification that decides fit is the SATA 6.0Gb/s interface, also listed as SATA/600. The motherboard or controller must support this standard for the drive to operate at its rated speed. No other interface type is supported by this unit.
Najważniejsze cechy
- 2 TB capacity stores large media libraries
- 7200 RPM spindle speed delivers fast data access
- SATA 6.0 Gb/s interface enables high transfer rates
- 5 inch form factor fits standard desktop bays
- Designed for Lenovo ThinkServer RS160 compatibility
Specyfikacja
| Brand | Lenovo |
|---|---|
| Interface | SATA 6.0Gb/s |
| Capacity | 2TB |
| RPM | 7200 RPM |
| Form Factor | 3.5" |
Pytania dotyczące tego produktu
Do I need a free 3.5" drive bay and a SATA 6.0Gb/s cable to install this Lenovo 2 TB drive?
Yes, the drive uses a 3.5" form factor and connects via a SATA 6.0Gb/s interface, so an available 3.5" bay and a standard SATA data cable are required.
Will this 7200 RPM SATA drive work on a motherboard that only supports SATA 3.0Gb/s?
The drive uses the SATA 6.0Gb/s standard which is backward compatible with SATA 3.0Gb/s controllers, so it will function at the lower speed.
How can I confirm the drive is recognised at its full 2 TB capacity and 7200 RPM speed after installation?
Check the BIOS or operating system disk utility; it should report a 2 TB capacity and the SATA 6.0Gb/s link speed, while SMART data or benchmark tools will show the 7200 RPM spindle speed.
Także w tym dziale
Klienci porównywali też te produkty
Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.
