Akceptujemy kryptowaluty — posiadane środki można więc wykorzystać na zakup prawdziwego sprzętu.Płatność kryptowalutą — realny sprzęt w zamian. Bezpłatna, ubezpieczona dostawa na całym świecie powyżej 399 $. Neutralne kartony, bez oznaczeń, wysyłane z Niemiec.Bezpłatna, ubezpieczona dostawa powyżej 399 $. Kurs zostaje zablokowany na 30 minut od otwarcia kasy.Kurs zablokowany na 30 minut. Każdy produkt jest fabrycznie zapieczętowany, jego numer seryjny jest sprawdzany, a całość objęta jest 24-miesięczną gwarancją.Zapieczętowane fabrycznie, 24 miesiące gwarancji.

Obserwowane produkty Zaloguj się
Green rectangular DDR4 SODIMM circuit board with black memory chips and gold edge connector

NEMIX RAM

NEMIX RAM 8GB DDR4 2133 CL15 2Rx8 1.2V 260-pin SODIMM POSIFLEX RT-5116 memory upgrade

SKU CH-537X-ATXTD

An 8 GB DDR4 SODIMM running at 2133 MHz CL15 for POSIFLEX RT-5116 terminals

  • Capacity8GB
  • SpeedDDR4 2133 (PC4 17000)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 8 GB capacity boosts POS terminal multitasking
  • DDR4 2133 speed matches system specification
  • CL15 latency supports responsive operation
  • 20 V low voltage reduces power draw
  • 260-pin SODIMM form factor fits POSIFLEX RT-5116

POSIFLEX RT-5116 terminal memory upgrade

This 8 GB DDR4 SODIMM is built specifically for the POSIFLEX RT-5116 point-of-sale terminal. It targets technicians and IT teams who need a direct-replacement module for that exact system. The stick is new, non-ECC, unbuffered and uses major-brand DRAM chips.

CL15 latency at DDR4-2133 decides fit

The module runs at 2133 MT/s with a CAS latency of 15 (PC4-17000) and a 2Rx8 rank structure. That timing and rank combination is what the RT-5116 firmware expects; a different latency or rank layout can prevent the terminal from posting.

Fits the 260-pin SODIMM slot in minutes

Installation is a standard SODIMM swap: power down, open the access panel, align the notch and press until the clips latch. The most common issue is leaving the module slightly unseated, which causes a no-boot condition; re-seating firmly usually resolves it.

Najważniejsze cechy

  • 8 GB capacity boosts POS terminal multitasking
  • DDR4 2133 speed matches system specification
  • CL15 latency supports responsive operation
  • 20 V low voltage reduces power draw
  • 260-pin SODIMM form factor fits POSIFLEX RT-5116

Specyfikacja

BrandNEMIX RAM
SeriesPOSIFLEX POS Series Point of Sale Kiosk Memory
ModelPOSIFLEX POS DDR4 2133MHZ Non-ECC Unbuffered SODIMM
Part NumberMS17000-828K1
Capacity8GB
SpeedDDR4 2133 (PC4 17000)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemPOSIFLEX POS
CAS LatencyCL15
Heat SpreaderNo
Type260-Pin DDR4 SODIMM
Rank2Rx8
FeaturesDDR4 Non-ECC Unbuffered SODIMM Motherboard Compatible
Package Content8GB (1X8GB) DDR4 2133MHZ PC4-17000 2Rx8 1.2V CL15 260-PIN Non-ECC Unbuffered SODIMM

Pytania dotyczące tego produktu

How does the 2133 MT/s rating translate once the module is installed in the POSIFLEX RT-5116?

The module runs at DDR4 2133 MT/s with CL15 latency, delivering the standard PC4-17000 bandwidth for the terminal's memory controller.

What does the 260-pin SODIMM interface cap in practice for this upgrade?

The 260-pin DDR4 SODIMM form factor limits the module to single-channel, unbuffered operation at 1.2 V on the POSIFLEX platform.

Will the 2Rx8 stick fit the RT-5116 without a heat spreader or extra clearance?

Yes, the bare 260-pin SODIMM has no heat spreader and uses the standard low-profile height, so it seats directly in the terminal's slot.

Także w tym dziale

Klienci porównywali też te produkty

Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.