NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Akceptujemy kryptowaluty — posiadane środki można więc wykorzystać na zakup prawdziwego sprzętu.Płatność kryptowalutą — realny sprzęt w zamian. Bezpłatna, ubezpieczona dostawa na całym świecie powyżej 399 $. Neutralne kartony, bez oznaczeń, wysyłane z Niemiec.Bezpłatna, ubezpieczona dostawa powyżej 399 $. Kurs zostaje zablokowany na 30 minut od otwarcia kasy.Kurs zablokowany na 30 minut. Każdy produkt jest fabrycznie zapieczętowany, jego numer seryjny jest sprawdzany, a całość objęta jest 24-miesięczną gwarancją.Zapieczętowane fabrycznie, 24 miesiące gwarancji.
RIMLANCE
An 8 GB dual-channel DDR3 kit running at 1866 MHz with CL13 latency and 1.35 V operation
This 8 GB kit contains two 4 GB UDIMM modules rated at 1866 MHz with CL13 latency. It targets users upgrading older DDR3 desktops who need a matched pair for dual-channel operation. The 1.35 V operating voltage reduces power draw compared to standard 1.5 V modules.
Low-voltage DDR3 runs cooler than standard-voltage equivalents, helping system thermals under load. Passive heatspreaders dissipate heat silently without adding fan noise. The kit draws less power at 1.35 V, easing demand on the motherboard voltage regulator during sustained workloads.
Two matched modules enable dual-channel bandwidth on compatible motherboards, doubling throughput versus a single stick. UDIMM form factor allows direct installation without tools or configuration. Major-brand chips provide validated stability for everyday multitasking and legacy application support.
| Brand | RIMLANCE |
|---|---|
| Model | RUD14900LS8C2K8 |
| Capacity | 8GB (2 x 4GB) |
| Speed | DDR3 1866 (PC3 14900) |
| CAS Latency | CL13 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chipset |
The modules are rated for 1866 MHz CL13 at 1.35 V; they will operate at that speed if the motherboard supports DDR3 1866 and the BIOS is set accordingly, otherwise they will run at the highest speed the board allows.
The kit uses standard UDIMM DDR3 form factor, unbuffered, non-ECC, 1.35 V; it fits any desktop motherboard with DDR3 slots that accept 1.35 V modules.
Install both 4 GB modules in the matching-colour slots on the motherboard; most boards enable dual-channel automatically, but you can verify in the BIOS that both channels show as active.
Także w tym dziale
Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.
Waluta płatności i waluta wyświetlania cen.
Wysyłane z portfela przy kasie
Tylko podgląd — katalog wyceniony jest w dolarach
Brak pasującej waluty.
Wybierz język, w którym wyświetla się strona.
Pierwsza wizyta?
Konto już założone?
Nie ma automatycznego resetowania hasła: ten sklep nie wysyła żadnych e-maili, więc nie ma jednorazowego linku, o który można by poprosić. Adres pozostawiony przy koncie zostanie obsłużony ręcznie.
Zgłoszenie zapisane
Do skrzynki odbiorczej nic nie trafi — ten sklep nie wysyła żadnych e-maili. Zgłoszenia są obsługiwane ręcznie.
Hasło się przypomniało?