Prijímame kryptomeny — takže mince, ktoré držíte, môžete zameniť za skutočný hardvér.Plaťte v krypte, miňte ho na skutočný hardvér. Poistená doprava zadarmo po celom svete nad 399 $. Neutrálne kartóny bez potlače, odosielané z Nemecka.Poistená doprava zadarmo nad 399 $. Váš kurz je zablokovaný na 30 minút hneď po otvorení pokladne.Kurz zablokovaný na 30 minút. Každý produkt je zapečatený, jeho sériové číslo je overené a vzťahuje sa naň 24-mesačná záruka.Zapečatené, 24-mesačná záruka.

Sledované položky Prihlásiť sa
Green circuit board with black memory chips, gold edge connector, no heat spreader

NEMIX RAM

NEMIX RAM 32GB DDR5 5600MHz CL46 2Rx8 UDIMM for Supermicro X13SAW-F memory upgrade

SKU CH-GEVY-7B2ED

32GB DDR5 5600MHz CL46 UDIMM built for Supermicro X13SAW-F motherboards

  • Capacity32GB
  • Type288-Pin DDR5 UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCNo

Size 32GB

  • Exact-match 32 GB DDR5-5600 upgrade for Supermicro X13SAW-F
  • Verified 288-pin UDIMM fitment, no ECC or SODIMM mismatch
  • Major OEM Samsung, Micron or Hynix chips tested at rated speed
  • 1 V CL46 2Rx8 timing recognised at full capacity by memory controller
  • Lifetime replacement warranty with US-based technical support

Exact-match DDR5 upgrade

This 32 GB DDR5 5600 MHz UDIMM is built to the precise rank, voltage and timing the Supermicro X13SAW-F memory controller expects. It delivers the full rated capacity and speed without manual tuning. The module uses major OEM chips from Samsung, Micron or Hynix and is tested for stability at the specified CL46 latency and 1.1 V operation. It is a non-ECC, unbuffered DIMM designed for desktop PC use on the validated platform.

Simple 288-pin installation

Installation follows the standard UDIMM procedure: align the notch with the slot key, press firmly until the retention clips engage, then verify the module is recognised in the BIOS. The most common issue is an incomplete seating that prevents the system from posting at the rated 5600 MHz speed. The motherboard manual should be consulted for the approved DIMM population order and any maximum capacity limits before purchase. No heat spreader is fitted, so airflow around the modules is unimpeded.

Builders upgrading the X13SAW-F

This kit suits anyone adding 32 GB of DDR5 5600 memory to a Supermicro X13SAW-F motherboard that accepts non-ECC unbuffered UDIMMs. It is not suitable for systems that require ECC registered modules, SODIMM form factors, or a different DDR generation. Buyers needing more than a single 32 GB module should check the board's maximum supported capacity and slot count first. Those running platforms validated only for lower DDR5 speeds will not achieve the rated frequency.

Prednosti

  • Exact-match 32 GB DDR5-5600 upgrade for Supermicro X13SAW-F
  • Verified 288-pin UDIMM fitment, no ECC or SODIMM mismatch
  • Major OEM Samsung, Micron or Hynix chips tested at rated speed
  • 1 V CL46 2Rx8 timing recognised at full capacity by memory controller
  • Lifetime replacement warranty with US-based technical support

Špecifikácie

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-328K1
Capacity32GB
Type288-Pin DDR5 UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Ďalšie verzie tohto modelu

Ďalších 5 v tomto rade

Rovnaký rad, iná pamäť, chladič alebo frekvencia — porovnajte pred rozhodnutím.

Otázky k tomuto produktu

How do I verify the memory is running at DDR5 5600 CL46 after installing it in my Supermicro X13SAW-F?

Enter the BIOS and confirm the memory speed shows 5600 MT/s with CAS latency 46; the module operates at 1.1 V and uses a 2Rx8 unbuffered design, so the board should detect it at full rated settings without manual tuning.

What comes in the package and is anything else required for installation?

The box contains one 32 GB DDR5 5600 PC5-44800 2Rx8 1.1 V CL46 288-pin non-ECC UDIMM (part number MD44800-328K1); no heat spreader or extra cables are included, and no additional parts are needed to install it in a compatible UDIMM slot.

Should I choose this 32 GB 2Rx8 module or a different capacity for the X13SAW-F?

This 32 GB 2Rx8 UDIMM matches the exact rank, voltage and timing the X13SAW-F expects; select it when your configuration calls for a single 32 GB module — consult the motherboard manual for supported capacities and DIMM population order before deciding.

Aj v tomto oddelení

Zákazníci tiež porovnávali

Rovnaké oddelenie, rovnaká pokladňa — osem mien a kurz zablokovaný na 30 minút.