NEMIX RAM 32GB DDR5 5600MHz CL46 2Rx8 UDIMM for Supermicro X13SAW-F memory upgrade

Exact-match DDR5 upgrade

This 32 GB DDR5 5600 MHz UDIMM is built to the precise rank, voltage and timing the Supermicro X13SAW-F memory controller expects. It delivers the full rated capacity and speed without manual tuning. The module uses major OEM chips from Samsung, Micron or Hynix and is tested for stability at the specified CL46 latency and 1.1 V operation. It is a non-ECC, unbuffered DIMM designed for desktop PC use on the validated platform.

Simple 288-pin installation

Installation follows the standard UDIMM procedure: align the notch with the slot key, press firmly until the retention clips engage, then verify the module is recognised in the BIOS. The most common issue is an incomplete seating that prevents the system from posting at the rated 5600 MHz speed. The motherboard manual should be consulted for the approved DIMM population order and any maximum capacity limits before purchase. No heat spreader is fitted, so airflow around the modules is unimpeded.

Builders upgrading the X13SAW-F

This kit suits anyone adding 32 GB of DDR5 5600 memory to a Supermicro X13SAW-F motherboard that accepts non-ECC unbuffered UDIMMs. It is not suitable for systems that require ECC registered modules, SODIMM form factors, or a different DDR generation. Buyers needing more than a single 32 GB module should check the board's maximum supported capacity and slot count first. Those running platforms validated only for lower DDR5 speeds will not achieve the rated frequency.