NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
Vi tar emot kryptovaluta — så att kryptot du äger kan köpa riktig hårdvara.Betala med krypto, använd det till riktig hårdvara. Fri, försäkrad frakt över hela världen vid köp över 399 $. Neutrala, omärkta ytterkartonger, skickade från Tyskland.Fri, försäkrad frakt över 399 $. Din kurs låses i 30 minuter så snart kassan öppnas.Kursen låst i 30 minuter. Varje artikel är förseglad, har kontrollerat serienummer och täcks av 24 månaders garanti.Förseglad, 24 månaders garanti.
SAMSUNG
8GB DDR3 registered ECC server memory module running at 1.35V with CL11 latency
This 8 GB registered DIMM uses 240-pin DDR3 SDRAM with ECC and a CL11 latency profile. It is built for servers and workstations that require error correction and signal buffering. The 1.35 V operating voltage helps reduce power draw in dense memory configurations. Systems without registered-memory support cannot use this module.
On-board error-correcting code detects and corrects single-bit errors to protect data integrity. Registered buffering lightens the electrical load on the memory controller, allowing larger total capacities per channel. The 1Rx4 rank organisation suits platforms qualified for single-rank registered DIMMs. No additional software or accessories are included to alter this behaviour.
The standard 240-pin layout fits DDR3 registered DIMM sockets in qualified server boards. Gold-edge contacts resist oxidation in continuously powered environments. Major-brand DRAM chips are used throughout for consistent yield. The 1.35 V specification matches low-voltage DDR3 server platforms; boards locked to 1.5 V will not post with this module.
| Brand | SAMSUNG |
|---|---|
| Model | M393B1G70Bh0-Yk0 |
| Capacity | 8GB |
| Type | 240-Pin DDR3 SDRAM |
| Speed | DDR3 SDRAM |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | ECC |
| Buffered/Registered | Registered |
| Rank | 1Rx4 |
| Chipset | Major Brand Chipset |
Registered ECC modules add a register that lessens electrical load on the memory controller, which can improve signal integrity and reduce correctable error counts over time.
The CL11 latency and 240-pin DDR3 interface set the timing ceiling; sustained throughput is bounded by the bus clock rather than the CAS figure alone.
Operating at 1.35 V lowers power draw per module versus standard 1.5 V DDR3, reducing thermal load inside a fully populated chassis.
Även i den här avdelningen
Samma hylla, samma kassa — åtta mynt och ett 30-minuters kurslås.
Det du betalar med, och det du ser priserna i.
Skickas från din plånbok i kassan
Endast visning — katalogen är prissatt i US-dollar
Ingen valuta matchar.
Välj det språk du vill att webbplatsen ska visas på.
Ny här?
Har du redan ett konto?
Det finns ingen automatisk återställning: den här butiken skickar inga e-postmeddelanden, så det finns ingen engångslänk att begära. Lämna adressen kopplad till kontot, så hanteras den för hand.
Förfrågan noterad
Inget är på väg till din inkorg — den här butiken skickar aldrig e-post. Någon tar hand om detta manuellt.
Kom du på det?