NEMIX RAM MR38400-618K4 64GB (4x16GB) DDR5 4800 ECC RDIMM

Targeted Server Memory Kit

This NEMIX RAM kit provides 64GB of DDR5 memory in a matched set of four 16GB modules. It is built for ASRock WRX90 WS EVO motherboards that require registered ECC DIMMs. System integrators and IT professionals handling mission-critical workloads will find the specification aligned with enterprise stability requirements. The registered design and error-correcting code suit multi-socket server boards rather than consumer desktops.

Build Integration Requirements

Each module uses a 288-pin DDR5 RDIMM form factor and operates at 1.10V with a CL40 latency. The registered buffer reduces electrical load on the memory controller, freeing the platform to populate all slots without signal degradation. Installation follows standard server DIMM procedures; the kit assumes the motherboard firmware supports the stated speed and rank configuration. Buyers needing unbuffered or non-ECC memory for consumer platforms cannot use this product.

Sustained Load Behaviour

Modules are stress-tested under load before shipping to verify reliability during continuous operation. The 1Rx8 organisation and Samsung, Micron or Hynix chipsets deliver consistent throughput at the rated 4800MT/s data rate. Error-correcting code detects and corrects single-bit errors in real time, preserving data integrity during long compute runs. Systems without registered ECC support will not benefit from these protection mechanisms.