EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
A-Tech
16GB DDR3L 1333 ECC registered server DIMM with 2Rx4 layout and 1.35V low voltage
This 16GB DDR3L 1333MHz registered DIMM delivers error-correcting memory for server and workstation platforms. It operates at 1.35V low voltage with CL9 latency and uses a 2Rx4 organisation on a 240-pin interface. The module replaces specific Hynix part numbers and undergoes quality assurance testing for dependable operation.
This memory fits systems that require DDR3L ECC registered DIMMs and accept 1.35V modules at 1333MHz. It will not work in platforms that need unbuffered UDIMMs, non-ECC memory, standard 1.5V DDR3, or different DDR generations. Builders without registered ECC support should look at other memory types.
The 1x16GB configuration occupies one registered DIMM slot, leaving other slots available for further capacity expansion within the platform limits. The low-voltage DDR3L design reduces power draw per module compared to standard DDR3. Verify your system's qualified vendor list and maximum supported capacity before installation.
| Brand | A-Tech |
|---|---|
| Capacity | 16GB |
| Speed | DDR3L 1333 (PC3L 10600) |
| CAS Latency | CL9 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
Yes, the module is a DDR3L 1333 (PC3L-10600) ECC RDIMM that requires a 240-pin registered DDR3L slot supporting 1.35V operation.
No, registered and unbuffered DIMMs cannot be mixed; the motherboard must support registered memory and all populated slots should use registered modules.
Check the BIOS memory information or run a tool such as dmidecode to verify speed shows 1333 MT/s, voltage reads 1.35V, and ECC status reports enabled.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟