EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
A-Tech
4GB DDR3L 1600 ECC registered DIMM with CL11 latency and 1.35V low-voltage operation for server upgrades
This 4GB registered ECC module runs at DDR3L 1600 (PC3L-12800) with a CAS latency of CL11 and a low operating voltage of 1.35V. It is built for server and workstation platforms that require registered DIMMs with error-correcting code. The single 2Rx8 rank stick fits 240-pin DDR3 slots.
The registered design places a buffer on the command and address lines to reduce electrical load on the memory controller, which helps stability in multi-DIMM server configurations. Major-brand DRAM chips are used throughout and each module undergoes quality-assurance testing before shipment. The 1.35V DDR3L voltage lowers power draw compared with standard 1.5V DDR3 while remaining compatible with slots that accept low-voltage modules.
This module matches the part numbers 46W0735, 0C19533 and 46W0692, making it a drop-in upgrade for compatible IBM-Lenovo systems. The jump is worth it when a server or workstation shows sluggish multitasking, frequent paging or memory-related errors that ECC can correct. Buyers who need non-ECC unbuffered memory for consumer desktops or laptops should look elsewhere.
| Brand | A-Tech |
|---|---|
| Capacity | 4GB |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
This module operates at DDR3L 1600 with a PC3L 12800 rating, delivering 1600 MT/s bandwidth at 1.35V.
The stick uses the standard 240-pin DDR3 DIMM form factor with registered signalling; it fits any DDR3 RDIMM slot that accepts 2Rx8 modules.
Power down, open the chassis, align the notch with the slot key, press firmly until both retention clips click, then verify in BIOS that ECC and registered mode are enabled.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟