NEMIX RAM 64GB DDR4 3200 4Rx4 1.2V 288-PIN ECC LRDIMM server RAM
- DDR4 3200 (PC4 2560…
- 22
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A-Tech
4GB DDR3L 1600 ECC registered DIMM with CL11 latency and 1.35V low-voltage operation for server upgrades
This 4GB registered ECC module runs at DDR3L 1600 (PC3L-12800) with a CAS latency of CL11 and a low operating voltage of 1.35V. It is built for server and workstation platforms that require registered DIMMs with error-correcting code. The single 2Rx8 rank stick fits 240-pin DDR3 slots.
The registered design places a buffer on the command and address lines to reduce electrical load on the memory controller, which helps stability in multi-DIMM server configurations. Major-brand DRAM chips are used throughout and each module undergoes quality-assurance testing before shipment. The 1.35V DDR3L voltage lowers power draw compared with standard 1.5V DDR3 while remaining compatible with slots that accept low-voltage modules.
This module matches the part numbers 46W0735, 0C19533 and 46W0692, making it a drop-in upgrade for compatible IBM-Lenovo systems. The jump is worth it when a server or workstation shows sluggish multitasking, frequent paging or memory-related errors that ECC can correct. Buyers who need non-ECC unbuffered memory for consumer desktops or laptops should look elsewhere.
| Brand | A-Tech |
|---|---|
| Capacity | 4GB |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
This module operates at DDR3L 1600 with a PC3L 12800 rating, delivering 1600 MT/s bandwidth at 1.35V.
The stick uses the standard 240-pin DDR3 DIMM form factor with registered signalling; it fits any DDR3 RDIMM slot that accepts 2Rx8 modules.
Power down, open the chassis, align the notch with the slot key, press firmly until both retention clips click, then verify in BIOS that ECC and registered mode are enabled.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?