EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
Computer Memory Solutions
8GB DDR3 1066 SO-DIMM kit validated for Supermicro C7X58, X8SAX, X8ST3-F and X8STE motherboards
This 8 GB kit contains two 4 GB DDR3 1066 SO-DIMM modules built for Supermicro C7X58, X8SAX, X8ST3-F and X8STE motherboards. The unbuffered, non-ECC sticks run at 1.5 V with CL7 timings and use major-brand chipsets under the Computer Memory Solutions guarantee.
The modules must be installed in pairs to enable dual-channel operation on the supported boards. Builders who need ECC error correction, registered DIMMs, higher speeds or larger single-module capacities should look at a different specification.
Each stick is a 204-pin SO-DIMM rated at PC3-8500 with 2Rx8 organisation. This physical and electrical interface is the single specification that determines whether the kit will fit and function in the target Supermicro systems.
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM512648500DIMMDR |
| Capacity | 8GB (2 x 4GB) |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Timing | 7-7-7 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Supermicro C7X58, X8Sax, X8St3-F, X8Ste Motherboard |
| Package Content | 2 Memory RAM Sticks |
The kit contains two 4GB modules that must be installed in pairs for dual-channel operation on the C7X58, X8SAX, X8ST3-F or X8STE boards.
The modules run at 1066 MHz (PC3 8500) with CL7 timing and 1.5 V, providing the rated bandwidth when the motherboard supports that frequency.
No, this kit uses 204-pin DDR3 SO-DIMMs, while the listed Supermicro boards require 240-pin DIMMs, so they are physically incompatible.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟