NEMIX RAM 288GB (6x48GB) DDR5 6400 CL52 2Rx8 ECC RDIMM memory upgrade

Exact-match DDR5 server kit

This 288GB kit contains six 48GB DDR5-6400 Registered ECC RDIMMs built to the precise rank, voltage and timing the GIGABYTE MZ73-LM0 motherboard expects. The modules operate at 1.1V with CL52 latency and a 2Rx8 organisation, so the memory controller recognises the full capacity and runs at the rated 6400 MT/s speed. It is intended for administrators who need maximum supported memory in a compatible server platform.

Registered ECC DDR5 constraints

Registered (buffered) architecture offloads the memory controller, allowing every slot to run fully populated at full capacity while ECC corrects single-bit errors on the fly to prevent silent data corruption. The 288-pin RDIMM form factor is required; UDIMM or SODIMM modules will not fit or function. Population rules and maximum supported capacity vary by motherboard revision, so the system manual must be consulted before installation.

Straightforward slot installation

Modules install by aligning the key notch with the 288-pin DDR5 slot and pressing firmly until the retention clips engage; no heat spreader is present, so clearance is minimal. Common issues arise when the population order in the manual is ignored, when a UDIMM is mistakenly used, or when the BIOS is not updated to support the full 288GB configuration. Consult the motherboard documentation for the approved DIMM sequence and firmware requirements.