OWC 32GB (2x16GB) DDR5 4800 CL40 ECC RDIMM HP Gen11
- 32GB (2 x 16GB)
- 288-Pin DDR5 ECC RD…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
OWC
32 GB DDR5 4800 CL40 ECC registered RDIMM for Dell PowerEdge R6625, R760, R7615 and R7625 servers
This 32GB DDR5 4800 CL40 registered module is built for Dell PowerEdge R6625, R760, R7615 and R7625 servers. It delivers error-correcting, registered memory for workloads that require data integrity and platform-specific qualification. The single DIMM occupies one 288-pin slot and runs at 1.1V.
The module uses a registered buffer and 2Rx8 rank structure, which the target platforms expect for stable operation at 4800 MT/s. No heat spreader is fitted, so airflow in the server chassis handles cooling directly. Mixing with unbuffered or load-reduced DIMMs is not supported by the memory controller.
This part number matches the OEM specification for a direct memory upgrade or replacement in the listed PowerEdge models. The jump is worthwhile when expanding capacity beyond the factory configuration or when a failed DIMM must be swapped with a qualified equivalent. Builders needing unbuffered memory or consumer platforms cannot use this module.
| Brand | OWC |
|---|---|
| Part Number | 4R8D52R832GB |
| Capacity | 32GB |
| Type | 288-Pin DDR5 ECC RDIMM |
| Speed | DDR5 4800 (PC5 38400) |
| CAS Latency | CL40 |
| Voltage | 1.1V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | Dell PowerEdge R6625 Dell PowerEdge R760 Dell PowerEdge R7615 Dell PowerEdge R7625 |
إصدارات أخرى من هذا الطراز
نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.
Yes, the module runs at DDR5 4800 (PC5-38400) with CL40 latency, which is the rated speed for the supported PowerEdge platforms.
It requires a standard 288-pin DDR5 DIMM slot; the registered 2Rx8 design fits the server memory channels used by these models.
Power down the server, open the chassis, align the notch on the 288-pin edge connector, press firmly until the retention clips lock, then verify in BIOS that ECC registered mode is active.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
لا توجد لغة مطابقة.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟