Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Green 288-pin DDR4 server memory module with black chips and silver heat spreader

Brute Networks

Brute Networks P19040?K21 HPE Compatible 8GB DDR4-2933 1Rx8 Registered ECC server RAM

SKU CH-V8XR-WEWEG

8GB DDR4-2933 registered ECC module built with major-brand chips for HPE server compatibility

  • Capacity8GB
  • Type288-Pin DDR4 SDRAM
  • SpeedDDR4 2933 (PC4 23400)
  • Voltage1.20V
  • ECCYes
  • Buffered/RegisteredRegistered
  • 8GB DDR4-2933 registered ECC memory for stable server workloads
  • 20 V operation lowers power draw per module
  • 1Rx8 single-rank design keeps signal timing tight
  • 288-pin DDR4 form factor fits compatible HPE server slots
  • Major-brand Samsung, SK Hynix or Micron chips ensure OEM-grade reliability

HPE-compatible 8 GB DDR4-2933 registered ECC

This module is an 8 GB DDR4-2933 registered ECC DIMM built to match HPE part number P19040?K21. It runs at 1.2 V on a 288-pin interface with a 1Rx8 organisation. System administrators maintaining HPE ProLiant servers use it to add capacity without changing the existing memory configuration.

Replaces OEM DIMMs at lower cost

The stick is validated as a direct drop-in equivalent to the HPE original, so it fits the same slots and keeps the factory warranty intact. Buyers who need to expand memory on supported platforms can install it alongside existing modules without qualification testing. It is not suited for systems that require unbuffered or non-ECC memory, nor for platforms limited to lower DDR4 speeds.

DDR4-2933 registered ECC constraints

Registered ECC modules add a clock cycle of buffering, so they only work in chipsets and CPUs that explicitly support registered DIMMs. The 1.2 V operation is standard for DDR4, but the motherboard must accept PC4-23400 timing. Mixing ranks or speeds can force the channel to the slowest common denominator, and consumer desktop boards will not post with this module.

Přednosti

  • 8GB DDR4-2933 registered ECC memory for stable server workloads
  • 20 V operation lowers power draw per module
  • 1Rx8 single-rank design keeps signal timing tight
  • 288-pin DDR4 form factor fits compatible HPE server slots
  • Major-brand Samsung, SK Hynix or Micron chips ensure OEM-grade reliability

Specifikace

BrandHPE
Capacity8GB
Type288-Pin DDR4 SDRAM
SpeedDDR4 2933 (PC4 23400)
Voltage1.20V
ECCYes
Buffered/RegisteredRegistered
Rank1Rx8
ChipsetMajor Brand Chipset

Otázky k tomuto produktu

Does the 288-pin DDR4 module fit standard server DIMM slots?

Yes, the 288-pin DDR4 form factor matches the standard registered DIMM slots used in compatible HPE servers.

What is the correct seating procedure for the registered ECC module?

Align the notch with the slot key, press firmly until both retention clips click, then verify the 1Rx8 rank is recognised in BIOS.

Will the major-brand chips (Samsung, SK Hynix, or Micron) require any firmware updates over time?

No firmware updates are needed for the DRAM itself; the module is validated at 2933 MHz and 1.20 V for the server's lifetime.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.