Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Black ATX power supply, full modular cables, 135 mm fan, 150 mm long

MSI

MSI MPG A1000G PCIE5 1000W power supply

SKU CH-4DJ3-66Z6E

Fully modular ATX 3.0 unit delivers 1000 W with a 16-pin PCIe 5.0 cable, 80 PLUS Gold efficiency and a 135 mm fluid-dynamic fan

  • ColorBlack
  • TypeATX 3.0 Compatible
  • Maximum Power1000 W
  • Fans1 x 135 mm Fluid Dynamic Bearing Fan
  • PFCActive
  • Main Connector24Pin
  • 80 PLUS Gold certification delivers over 90% efficiency at typical loads
  • PCIe 5.0 and ATX 3.0 compatibility includes a 16-pin 12VHPWR connector for 4080 and 4090 graphics cards
  • Full modular design with flat cables lets you connect only the 24-pin, six 6+2-pin and twelve SATA leads you need
  • 135 mm fluid dynamic bearing fan with 0 RPM mode runs silently until higher loads demand airflow
  • Single +12V rail backed by OCP, OVP, OPP, OTP, SCP and UVP protections safeguards every component

1000 W ATX 3.0 power supply

The MSI MPG A1000G PCIE5 delivers 1000 W through a single +12 V rail and meets the ATX 3.0 and PCIe 5.0 specifications. It includes a 16-pin 12VHPWR cable alongside six 6+2-pin PCIe connectors and twelve SATA power connectors. A 135 mm fluid-dynamic-bearing fan runs with a 0 RPM mode at low load, and the unit carries 80 PLUS Gold certification with Cybenetics Standard++ noise rating.

Suitable for high-end GPU builds.

This unit suits builders pairing a 4080 or 4090 graphics card with a modern motherboard that needs the 12VHPWR connection. The 150 mm depth and full-modular flat cables help cable management in standard ATX towers. Systems limited to shorter PSU bays or builds that do not require the new 16-pin interface should consider a smaller or older-specification unit.

12VHPWR connector decides compatibility

The defining specification is the native 16-pin 12VHPWR cable, which allows direct power delivery to PCIe 5.0 graphics cards without an adapter. If the target GPU uses only traditional 6+2-pin connectors, the 12VHPWR cable will remain unused and a different PSU may be more cost-effective.

Přednosti

  • 80 PLUS Gold certification delivers over 90% efficiency at typical loads
  • PCIe 5.0 and ATX 3.0 compatibility includes a 16-pin 12VHPWR connector for 4080 and 4090 graphics cards
  • Full modular design with flat cables lets you connect only the 24-pin, six 6+2-pin and twelve SATA leads you need
  • 135 mm fluid dynamic bearing fan with 0 RPM mode runs silently until higher loads demand airflow
  • Single +12V rail backed by OCP, OVP, OPP, OTP, SCP and UVP protections safeguards every component

Specifikace

BrandMSI
ModelMPG A1000G PCIE5
ColorBlack
TypeATX 3.0 Compatible
Maximum Power1000 W
Fans1 x 135 mm Fluid Dynamic Bearing Fan
PFCActive
Main Connector24Pin
+12V RailsSingle
PCI-Express Connector1 x 16-Pin, 6 x 6+2-Pin
SATA Power Connector12
Max PSU Length150 mm
ModularFull Modular
Efficiency> 90%
Energy-Efficient80 PLUS GOLD Certified
PSU Noise LevelCybenetics Standard ++
ProtectionOCP, OVP, OPP, OTP, SCP, UVP
Input Voltage100 - 240 V
Input Frequency Range50/60 Hz
Output+5V@22A, +3.3V@22A, [email protected] , [email protected] , +5VSB@3A
Connectors1 x ATX (24 PIN)
2 x EPS (4+4 PIN)
1 x PCI-E 5.0 (16 PIN) (600W)
6 x PCI-E (6+2 PIN)
8 x SATA (15 PIN)
4 x MOLEX (4 PIN)
1 x FDD (4 PIN)
Cable Spec1 x ATX Cable (600mm)
2 x EPS (8 PIN to 4+4 PIN) Cable (700mm)
2 x PCIe (8 PIN to 6+2 PIN) Cable (600mm)
1 x PCIe (16 PIN to 16 PIN) Cable (600mm)
1 x PCIe (16 PIN to 6+2 PIN) Cable (600mm)
3 x SATA Sleeved Cable (500+150+150+150mm)
1 x MOLEX/FDD Sleeved Cable (500+150+150+150+150mm)
Features80 PLUS Gold Certification
PCIe 5.0 and ATX 3.0 Compatible
100% Japanese Electrolytic capacitor
Full Modular design
Active PFC design
Industrial level protection with OCP, OVP, OPP, OTP, SCP, UVP
DC-DC Module Design
Flat Cables
Single Rail Design
Fan 0 RPM Mode
Dimensions3.40" x 5.90" x 5.90"

Otázky k tomuto produktu

Will the 150 mm length and 135 mm fan fit my ATX case?

The unit is 150 mm long with a single 135 mm fluid dynamic bearing fan; measure your case clearance for both length and fan height before ordering.

Which cables must I plug in during installation, and which step is often missed?

Connect the 24 pin main cable, the 16 pin PCIe 5.0 cable for the GPU, and only the modular cables your build needs; the step most often missed is seating the 16 pin connector fully until it clicks.

How long should the 100 % Japanese electrolytic capacitors last under load?

The 100 % Japanese electrolytic capacitors are rated for long life at high temperature; expect many years of continuous operation before any replacement is needed.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.