Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Four green DDR4 UDIMM modules with black chips, no heat spreaders

NEMIX RAM

NEMIX RAM 128GB 4x32GB DDR4 3200MHz PC4-25600 CL22 ECC UDIMM memory upgrade

SKU CH-NP1W-F53MP

128 GB kit of four 32 GB DDR4 3200 MHz ECC UDIMMs at CL22 and 1.2 V for Supermicro X12STE-F and X12STD-F motherboards

  • Capacity128GB (4 x 32GB)
  • Type288-Pin DDR4 ECC UDIMM
  • SpeedDDR4 3200 (PC4 25600)
  • CAS LatencyCL22
  • Voltage1.20V
  • ECCYes

Size 128GB 4X32GB

  • 128 GB total capacity from four 32 GB modules for high-density workloads
  • DDR4 3200 MHz PC4-25600 speed matches the board's rated frequency
  • CL22 latency at 1.20 V delivers stable timing the controller expects
  • ECC UDIMM corrects single-bit errors to protect data integrity
  • Verified fitment for Supermicro X12STE-F and X12STD-F motherboards

Supermicro X12STE-F/X12STD-F upgrade

This 128GB kit uses four 32GB DDR4 3200MHz PC4-25600 ECC unbuffered UDIMMs built for Supermicro X12STE-F and X12STD-F motherboards. The modules run at 1.2V with CL22 timing and a 2Rx8 rank layout that matches the board's memory controller expectations. Error-correcting code protects data integrity for workloads that cannot tolerate silent corruption.

Exact-match replacement for mixed kits

The kit replaces mismatched or lower-capacity DIMMs that force the system to run at reduced speeds or disable ECC. Populating all four slots with identical 2Rx8 modules lets the controller train at the rated 3200MHz without downclocking. Builders who need registered RDIMMs or laptop SODIMMs cannot use this product.

Sustained ECC operation at rated speed

Under continuous load the unbuffered design keeps latency low while ECC corrects single-bit errors in real time. The 1.2V operating voltage stays within the motherboard's standard power envelope during extended sessions. Systems requiring higher frequencies or lower latencies than CL22 will not achieve those targets with this memory.

Přednosti

  • 128 GB total capacity from four 32 GB modules for high-density workloads
  • DDR4 3200 MHz PC4-25600 speed matches the board's rated frequency
  • CL22 latency at 1.20 V delivers stable timing the controller expects
  • ECC UDIMM corrects single-bit errors to protect data integrity
  • Verified fitment for Supermicro X12STE-F and X12STD-F motherboards

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR4 ECC Unbuffered UDIMM Memory
Part NumberME25600-328K4
Capacity128GB (4 x 32GB)
Type288-Pin DDR4 ECC UDIMM
SpeedDDR4 3200 (PC4 25600)
CAS LatencyCL22
Voltage1.20V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR4 ECC Unbuffered UDIMM Motherboard Compatible
Package Content128GB 4X32GB DDR4 3200MHz PC4-25600 2Rx8 1.2V 288-PIN ECC UDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Will the 288-pin DDR4 UDIMM modules fit the Supermicro X12STE-F motherboard?

Yes, the 288-pin DDR4 ECC UDIMM form factor matches the motherboard's DIMM slots exactly. The kit is verified for the X12STE-F and X12STD-F boards and is not an RDIMM or SODIMM.

What is the correct installation order for the four 32GB modules on the X12STE-F?

The motherboard manual defines the approved DIMM population order for 2Rx8 modules. Follow that sequence so the memory controller recognises the full 128GB at the rated 3200MHz speed.

Do these ECC UDIMMs require any firmware updates or ongoing maintenance after installation?

No firmware updates are needed for the memory itself. The modules run at 1.2V with CL22 timing. If a module ever fails, the lifetime replacement warranty covers a swap.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.