Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se
Black 60mm square case fan 15mm thick with 4-pin PWM connector

Zyvpee

Zyvpee AUB0612HHB-A 6015 12V .20A 4-pin PWM case fan

SKU CH-S322-BC8VE

A 60 mm PWM case fan with 4-pin control and ball-bearing operation at 12 V 0.2 A

  • TypeCPU Cooler Fan
  • Bearing TypeBall
  • Power Connector4 Pin
  • ColorBlack
  • LEDNon-LED
  • Dimensions60*15mm
  • PWM control adjusts speed to match cooling demand
  • 4-pin connector enables precise motherboard fan regulation
  • 60 × 15 mm frame fits compact 6015 mounting points
  • 12 V 0.20 A draw keeps power use low
  • Ball bearing design supports durable continuous operation

Compact 6015 Form Factor

The Zyvpee AUB0612HHB-A is a 60 mm by 15 mm case fan designed for confined spaces that cannot accommodate larger frames. It runs on a 12 V supply drawing .20 A and uses a four-pin PWM connector for automatic speed control. The ball-bearing motor and non-LED black housing target builders who need reliable airflow without illumination.

Suited for Small-Factor Builds

This fan fits servers or slim enclosures that specify a 6015 footprint and a four-wire PWM header. It is not intended for builds that require higher static pressure from a thicker or larger-diameter rotor, nor for systems limited to three-pin voltage control only.

Four-Pin PWM Connector Decides Fit

The 4-pin PWM header is the single specification that determines whether this unit can be speed-regulated by the motherboard or fan controller. Verify the header type and the 60*15 mm mounting pattern before ordering.

Přednosti

  • PWM control adjusts speed to match cooling demand
  • 4-pin connector enables precise motherboard fan regulation
  • 60 × 15 mm frame fits compact 6015 mounting points
  • 12 V 0.20 A draw keeps power use low
  • Ball bearing design supports durable continuous operation

Specifikace

Brand3ccooler.com
SeriesAUB0612HHB-A
ModelAUB0612HHB-A
TypeCPU Cooler Fan
Bearing TypeBall
Power Connector4 Pin
ColorBlack
LEDNon-LED
Dimensions60*15mm

Otázky k tomuto produktu

Does the 4-pin PWM connector on the AUB0612HHB-A let the motherboard control speed down to zero RPM?

The 4-pin PWM connector allows the motherboard to vary voltage and duty cycle, but minimum RPM depends on the fan's internal firmware and the board's fan curve settings.

Will the 60 mm by 15 mm frame fit a standard 60 mm fan mount with four corner holes?

The 60×15 mm dimensions match the common 60 mm square mounting pattern, so it aligns with typical four-hole case or heatsink brackets.

How do I plug the 4-wire PWM lead into a 3-pin header without losing speed control?

Insert the 4-pin connector onto the 3-pin header leaving the fourth pin exposed; the fan will run at full 12 V unless the board supports voltage-based control on that header.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.