Zyvpee
Zyvpee AUB0612HHB-A 6015 12V .20A 4-pin PWM case fan
A 60 mm PWM case fan with 4-pin control and ball-bearing operation at 12 V 0.2 A
- TypeCPU Cooler Fan
- Bearing TypeBall
- Power Connector4 Pin
- ColorBlack
- LEDNon-LED
- Dimensions60*15mm
- PWM control adjusts speed to match cooling demand
- 4-pin connector enables precise motherboard fan regulation
- 60 × 15 mm frame fits compact 6015 mounting points
- 12 V 0.20 A draw keeps power use low
- Ball bearing design supports durable continuous operation
Compact 6015 Form Factor
The Zyvpee AUB0612HHB-A is a 60 mm by 15 mm case fan designed for confined spaces that cannot accommodate larger frames. It runs on a 12 V supply drawing .20 A and uses a four-pin PWM connector for automatic speed control. The ball-bearing motor and non-LED black housing target builders who need reliable airflow without illumination.
Suited for Small-Factor Builds
This fan fits servers or slim enclosures that specify a 6015 footprint and a four-wire PWM header. It is not intended for builds that require higher static pressure from a thicker or larger-diameter rotor, nor for systems limited to three-pin voltage control only.
Four-Pin PWM Connector Decides Fit
The 4-pin PWM header is the single specification that determines whether this unit can be speed-regulated by the motherboard or fan controller. Verify the header type and the 60*15 mm mounting pattern before ordering.
特長
- PWM control adjusts speed to match cooling demand
- 4-pin connector enables precise motherboard fan regulation
- 60 × 15 mm frame fits compact 6015 mounting points
- 12 V 0.20 A draw keeps power use low
- Ball bearing design supports durable continuous operation
仕様
| Brand | 3ccooler.com |
|---|---|
| Series | AUB0612HHB-A |
| Model | AUB0612HHB-A |
| Type | CPU Cooler Fan |
| Bearing Type | Ball |
| Power Connector | 4 Pin |
| Color | Black |
| LED | Non-LED |
| Dimensions | 60*15mm |
この商品に関する質問
Does the 4-pin PWM connector on the AUB0612HHB-A let the motherboard control speed down to zero RPM?
The 4-pin PWM connector allows the motherboard to vary voltage and duty cycle, but minimum RPM depends on the fan's internal firmware and the board's fan curve settings.
Will the 60 mm by 15 mm frame fit a standard 60 mm fan mount with four corner holes?
The 60×15 mm dimensions match the common 60 mm square mounting pattern, so it aligns with typical four-hole case or heatsink brackets.
How do I plug the 4-wire PWM lead into a 3-pin header without losing speed control?
Insert the 4-pin connector onto the 3-pin header leaving the fourth pin exposed; the fan will run at full 12 V unless the board supports voltage-based control on that header.
同じ売り場の商品
よく比較されている商品
同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。
ModMyMods MOD-0002 3/8" ID x 1/2" OD Clear PVC Tubing DIY Cooling
- Clear



