NEMIX RAM 48GB DDR5 5600MHz CL46 2Rx8 ECC Registered RDIMM memory upgrade

Exact-match DDR5-5600 registered ECC module

This 48GB DDR5 5600MHz PC5-44800 RDIMM delivers CL46 latency at 1.1V in a 2Rx8 registered configuration. It is built for servers and workstations that require error-correcting memory and the electrical buffering of registered DIMMs to run fully populated at rated speed. The 288-pin form factor fits only DDR5 RDIMM slots.

Verified fitment for GIGABYTE MS34-CP0

The module is validated for the GIGABYTE MS34-CP0 motherboard, matching the board's required rank, voltage and timing so the firmware recognises the full 48GB capacity at DDR5-5600. Registered architecture offloads the memory controller, allowing every supported slot to operate at full load without signal degradation, while on-die ECC corrects single-bit errors before they reach the operating system.

DDR5 RDIMM population rules apply

Server memory controllers enforce strict population order and maximum capacity per channel that differ by platform; the manual for your specific motherboard defines which slots must be filled first and the total memory limit. Registered DIMMs cannot be mixed with unbuffered UDIMMs or SODIMMs, and the 288-pin keying prevents installation in any other DDR generation slot. Buyers needing higher density per module or non-ECC memory should select a different part.