OWC 8GB DDR3 1600 CL11 2Rx8 240-pin 1.5V Non-ECC UDIMM for Dell Precision T1700

Precision T1700 upgrade module

This single 8GB DDR3 UDIMM is built for the Dell Precision T1700 workstation. It adds memory capacity without requiring registered or error-correcting modules. The unbuffered design keeps installation straightforward for system integrators. Buyers needing ECC protection or higher-density registered DIMMs should select a different part.

1600 MHz CL11 DDR3 specification

The module runs at PC3-12800 speed with a CAS latency of 11 at 1.5V. JEDEC compliance guarantees the timing and voltage match the platform's memory controller expectations. The 2Rx8 organisation fits the T1700's dual-rank slot population rules. Systems that require a different speed grade or voltage will not accept this module.

Steady throughput under load

Continuous multi-threaded workloads keep the DRAM at its rated 1600 MHz without down-clocking. The absence of a heat spreader is offset by the workstation's directed airflow across the DIMM slots. Sustained bandwidth remains consistent during long render or compute sessions. Modules with lower speed ratings would throttle earlier under the same thermal conditions.