Zyvpee
Zyvpee KDE1204PKV1 40x20mm 12V .8W 2-wire case fan
A 40 mm square by 20 mm thick axial fan runs on 12 V DC at .8 W with Maglev bearings and a 2-wire power connector
- TypeCase Fan
- CompatibilityCase
- Bearing TypeMaglev
- Power Connector2 wires
- ColorBlack
- LEDNon-LED
- Maglev bearing reduces friction for quiet operation
- 12 V, .8 W draw keeps power use low
- 40 mm by 20 mm frame fits tight 4 cm spaces
- Two-wire DC connection simplifies installation
- Non-LED black design suits stealth builds
Zyvpee KDE1204PKV1 40x20mm case fan
This 40mm square axial fan fits standard case mounting points. It runs on 12V DC power and draws .8W. The Maglev bearing reduces friction and noise. Two wires supply power without speed reporting.
Suits tight 40mm mounts needing low power draw
Builders who need PWM speed control or a three or four wire header should look elsewhere. The two wire design only supports voltage regulation. Buyers wanting RGB lighting or higher airflow will need a different model.
Two wire 12V .8W power connector
The 2 wire connector delivers fixed 12V power at .8W. No tachometer or PWM signal is present. Speed varies only with voltage changes. Check that your board or controller provides a compatible two pin header.
Besonderheiten
- Maglev bearing reduces friction for quiet operation
- 12 V, .8 W draw keeps power use low
- 40 mm by 20 mm frame fits tight 4 cm spaces
- Two-wire DC connection simplifies installation
- Non-LED black design suits stealth builds
Technische Daten
| Series | KDE1204PKV1 |
|---|---|
| Model | KDE1204PKV1 |
| Type | Case Fan |
| Compatibility | Case |
| Bearing Type | Maglev |
| Power Connector | 2 wires |
| Color | Black |
| LED | Non-LED |
| Features | DC axial fan |
| Dimensions | 40*40*20mm |
Fragen zu diesem Artikel
Will the 40×20 mm frame with 2-wire lead fit my case fan mount?
The fan measures 40 mm square by 20 mm thick and uses a two-wire DC connection, so it fits any 40 mm mounting holes that accept a 20 mm deep frame.
How do I connect the two wires to a 12 V header without reversing polarity?
Match the red wire to the 12 V pin and the black wire to ground on the motherboard or controller header; reversing them will prevent the maglev motor from starting.
Does the maglev bearing need lubrication or replacement over time?
The magnetic-levitation bearing runs without contact, so no lubrication is required and there is no wearable sleeve or ball to replace.
Ebenfalls in dieser Kategorie
Kunden haben diese ebenfalls verglichen
Gleiche Abteilung, gleiche Kasse — acht Kryptowährungen und ein für 30 Minuten fixierter Kurs.
Black Box Corporation
Black Box Corporation DisplayPort to DVI Fibre Optic Cable 15 ft 4.5 m 1.35 GB/s
- Consumer Electronics
39,99 $
0.00051841BTC
Auf Lager