NEMIX RAM 4GB DDR3 1066 PC3-8500 CL7 1.5V 204-PIN SODIMM Laptop RAM
- 4GB
- 204-Pin DDR3 SO-DIMM
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
NEMIX RAM
8GB DDR3 1066 SODIMM module with CL7 latency and 1.5V operation for laptop memory upgrades
Capacity 8GB
This 8 GB DDR3 SODIMM runs at 1066 MHz with a CL7 latency and 1.5 V operation. It uses a 204‑pin unbuffered non‑ECC design suited to laptops, all‑in‑one PCs, small form factor systems and NAS devices. The single module format provides a straightforward capacity increase for compatible DDR3 platforms.
Without a heat spreader the module relies on the system’s existing airflow for cooling. At 1.50 V it draws the normal power expected for DDR3 1066 operation, adding no extra acoustic load. The unbuffered layout keeps electrical demand within standard SODIMM limits for the host device.
Each module undergoes stress testing under load to verify reliability during extended use. The CL7 timing and 1.5 V specification remain consistent when the memory is fully utilised over long periods. This makes the stick suitable for environments where continuous uptime is required.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM DDR3 Orignial Series 204-Pin NON-ECC Unbuffered SODIMM Memory |
| Model | DDR3 NON- ECC Unbuffered SODIMM Laptop, AIO, SFF, NAS Storage Device Memory |
| Part Number | MS8500-828K1 |
| Capacity | 8GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.50V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Features | DDR3 Laptop, AIO All-in-One, SFF, NAS Device Compatible |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Align the notch on the module with the key in the socket, insert it at an angle, then press down firmly until the retention clips snap into place on both sides.
No firmware is involved and there is no heat spreader or thermal pad to replace; the unbuffered DDR3 ICs run passively at the rated 1.50 volts.
The module operates at a fixed 1066 MT/s data rate with CL7 latency, so sustained bandwidth is capped by that DDR3 specification.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?