NEMIX RAM 4GB DDR3 1066 PC3-8500 CL7 1.5V 204-PIN SODIMM Laptop RAM
- 4GB
- 204-Pin DDR3 SO-DIMM
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
NEMIX RAM
8GB DDR3 1066 SODIMM module with CL7 latency and 1.5V operation for laptop memory upgrades
Capacity 8GB
This 8 GB DDR3 SODIMM runs at 1066 MHz with a CL7 latency and 1.5 V operation. It uses a 204‑pin unbuffered non‑ECC design suited to laptops, all‑in‑one PCs, small form factor systems and NAS devices. The single module format provides a straightforward capacity increase for compatible DDR3 platforms.
Without a heat spreader the module relies on the system’s existing airflow for cooling. At 1.50 V it draws the normal power expected for DDR3 1066 operation, adding no extra acoustic load. The unbuffered layout keeps electrical demand within standard SODIMM limits for the host device.
Each module undergoes stress testing under load to verify reliability during extended use. The CL7 timing and 1.5 V specification remain consistent when the memory is fully utilised over long periods. This makes the stick suitable for environments where continuous uptime is required.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM DDR3 Orignial Series 204-Pin NON-ECC Unbuffered SODIMM Memory |
| Model | DDR3 NON- ECC Unbuffered SODIMM Laptop, AIO, SFF, NAS Storage Device Memory |
| Part Number | MS8500-828K1 |
| Capacity | 8GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.50V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Features | DDR3 Laptop, AIO All-in-One, SFF, NAS Device Compatible |
إصدارات أخرى من هذا الطراز
نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.
Align the notch on the module with the key in the socket, insert it at an angle, then press down firmly until the retention clips snap into place on both sides.
No firmware is involved and there is no heat spreader or thermal pad to replace; the unbuffered DDR3 ICs run passively at the rated 1.50 volts.
The module operates at a fixed 1066 MT/s data rate with CL7 latency, so sustained bandwidth is capped by that DDR3 specification.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
لا توجد لغة مطابقة.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟