Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.

Seuratut tuotteet Kirjaudu sisään
Sixteen green DDR5 RDIMM modules in a row

NEMIX RAM

NEMIX RAM DDR5 5600 2TB (16x128GB) CL46 2Rx4 1.1V 288-pin ECC RDIMM Kit for Supermicro H14DST-F

SKU CH-Y8GZ-ER8GX

A 2 TB DDR5 registered ECC kit with sixteen 128 GB modules running at 5600 MHz, CL46, 1.1 V for the Supermicro H14DST-F

  • Capacity2TB (16 x 128GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 2TB 16X128GB

Näytä 30 muuta kokoonpanoa
  • 2TB capacity with 16 matched 128GB modules for maximum server density
  • DDR5 5600 speed rated at PC5-44800 for high-throughput workloads
  • Registered ECC design with 2Rx4 organisation corrects single-bit errors and offloads the memory controller
  • 10V operation at CL46 latency matches the motherboard's native timing profile
  • 288-pin RDIMM form factor validated for Supermicro H14DST-F memory population rules

2TB DDR5 ECC RDIMM kit for Supermicro H14DST-F

This 2TB kit contains 16 registered DDR5 DIMMs, each 128GB, built for the Supermicro H14DST-F motherboard. It runs at DDR5-5600 with CL46 latency at 1.10V. The 2Rx4 organisation and registered buffer let the board run every slot populated at rated speed. Target users operate memory-intensive servers that require error-correcting capacity at scale.

Verify DIMM population rules before ordering

Consult the H14DST-F manual for supported capacities per channel and the approved installation sequence. The board requires 288-pin registered RDIMMs; unbuffered UDIMMs or SODIMMs will not fit or function. Confirm the BIOS revision supports the full 16-module configuration at DDR5-5600. Buyers who need a different capacity or a non-registered form factor cannot use this kit.

Registered ECC modules without heat spreaders

Each DIMM uses major OEM Samsung, Micron or Hynix chips in a bare PCB design. The registered architecture reduces electrical load on the memory controller when all 16 slots are filled. ECC corrects single-bit errors in flight, preventing silent data corruption. The 1.10V operating voltage matches the DDR5 baseline for server platforms.

Kohokohdat

  • 2TB capacity with 16 matched 128GB modules for maximum server density
  • DDR5 5600 speed rated at PC5-44800 for high-throughput workloads
  • Registered ECC design with 2Rx4 organisation corrects single-bit errors and offloads the memory controller
  • 10V operation at CL46 latency matches the motherboard's native timing profile
  • 288-pin RDIMM form factor validated for Supermicro H14DST-F memory population rules

Tekniset tiedot

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-724K16
Capacity2TB (16 x 128GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content2TB 16X128GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Tämän mallin muut versiot

5 lisää samasta mallistosta

Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.

Kysymyksiä tästä tuotteesta

Does the 2TB kit include all 16 DDR5 5600 RDIMM modules or must any be purchased separately?

The kit ships as a complete 2TB package containing 16 modules of 128GB each, so nothing else is required for a full installation.

Why is the kit specified as 2Rx4 CL46 rather than a different rank or latency?

The 2Rx4 organisation and CL46 timing match the Supermicro H14DST-F memory controller requirements, ensuring the board recognises the full 2TB capacity at the rated DDR5 5600 speed.

What does the DDR5 5600 (PC5-44800) rating deliver once the modules are installed in the H14DST-F?

The server will run the memory at 5600 MT/s with a 1.10 V supply, providing the rated bandwidth and registered ECC stability across all 16 slots.

Myös tällä osastolla

Asiakkaat vertailivat myös näitä

Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.