OWC 64GB DDR4 2933MHz CL21 1.2V 288pin ECC Registered RDIMM memory upgrade
- 64GB
- 288-Pin DDR4 ECC RD…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
128GB DDR4 2933MHz ECC registered RDIMM for Supermicro X11 server motherboards
This 128GB DDR4 2933MHz CL21 registered module targets Supermicro X11DPG-SN, X11DPH-I, X11DPH-T, X11DPH-Tq and X11DPi-N motherboards. It delivers error-correcting, buffered memory for workloads that demand data integrity and high capacity. The kit is not compatible with standard desktop boards or unbuffered DIMMs.
Operating at 1.2V, the module runs without a heat spreader and relies on chassis airflow for cooling. Registered buffering reduces electrical load on the memory controller, helping to keep power draw predictable during sustained server tasks. No active cooling is included or required by the specification.
The 288-pin DDR4 form factor fits the listed Supermicro server platforms and supports backward-compatible speeds of 2133MHz, 2400MHz and 2666MHz. ECC registration frees the memory controller from parity duties, while the 4Rx4 organisation maximises density per slot. Mixing with unbuffered memory is not supported.
| Brand | OWC |
|---|---|
| Part Number | 2R9D44R4128G |
| Capacity | 128GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 2933 (PC4 23400) |
| CAS Latency | CL21 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 4Rx4 |
| Heat Spreader | No |
| Compatible System | Supermicro Motherboard X11DPG-SN Supermicro Motherboard X11DPH-I Supermicro Motherboard X11DPH-T Supermicro Motherboard X11DPH-Tq Supermicro Motherboard X11DPi-N |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power down the server, open the chassis, align the notch on the module with the slot key, press firmly until both ejector clips lock, then verify in BIOS that all 128GB are recognised at 2933MHz.
No scheduled maintenance is needed; ECC corrects single-bit errors on the fly, and the module should only be replaced if uncorrectable errors appear or a memory diagnostic reports a hard failure.
The registered buffer and 4Rx4 organisation add one clock cycle of latency, so the CL21 timing at 2933MHz becomes the primary latency ceiling before bandwidth or thermal limits are reached.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?