OWC 64GB DDR4 2933MHz CL21 1.2V 288pin ECC Registered RDIMM memory upgrade
- 64GB
- 288-Pin DDR4 ECC RD…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
OWC
128GB DDR4 2933MHz ECC registered RDIMM for Supermicro X11 server motherboards
This 128GB DDR4 2933MHz CL21 registered module targets Supermicro X11DPG-SN, X11DPH-I, X11DPH-T, X11DPH-Tq and X11DPi-N motherboards. It delivers error-correcting, buffered memory for workloads that demand data integrity and high capacity. The kit is not compatible with standard desktop boards or unbuffered DIMMs.
Operating at 1.2V, the module runs without a heat spreader and relies on chassis airflow for cooling. Registered buffering reduces electrical load on the memory controller, helping to keep power draw predictable during sustained server tasks. No active cooling is included or required by the specification.
The 288-pin DDR4 form factor fits the listed Supermicro server platforms and supports backward-compatible speeds of 2133MHz, 2400MHz and 2666MHz. ECC registration frees the memory controller from parity duties, while the 4Rx4 organisation maximises density per slot. Mixing with unbuffered memory is not supported.
| Brand | OWC |
|---|---|
| Part Number | 2R9D44R4128G |
| Capacity | 128GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 2933 (PC4 23400) |
| CAS Latency | CL21 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 4Rx4 |
| Heat Spreader | No |
| Compatible System | Supermicro Motherboard X11DPG-SN Supermicro Motherboard X11DPH-I Supermicro Motherboard X11DPH-T Supermicro Motherboard X11DPH-Tq Supermicro Motherboard X11DPi-N |
Other versions of this model
Same family, different memory, cooler or clock — compare before you commit.
Power down the server, open the chassis, align the notch on the module with the slot key, press firmly until both ejector clips lock, then verify in BIOS that all 128GB are recognised at 2933MHz.
No scheduled maintenance is needed; ECC corrects single-bit errors on the fly, and the module should only be replaced if uncorrectable errors appear or a memory diagnostic reports a hard failure.
The registered buffer and 4Rx4 organisation add one clock cycle of latency, so the CL21 timing at 2933MHz becomes the primary latency ceiling before bandwidth or thermal limits are reached.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?