OWC 16GB DDR4 2400 CL17 ECC Registered RDIMM 288-pin 1.2V Cisco UCS B260 M4 B460 M4 memory upgrade
- 16GB
- 288-Pin DDR4 ECC RD…
Hyväksymme kryptoa — hallussasi olevat kolikot voivat näin ostaa oikeaa laitteistoa.Maksa kryptolla, käytä se oikeaan laitteistoon. Ilmainen vakuutettu toimitus maailmanlaajuisesti yli 399 $. Neutraalit, tuotemerkittömät ulkopakkaukset, lähetetään Saksasta.Ilmainen vakuutettu toimitus yli 399 $. Kurssisi lukitaan 30 minuutiksi heti, kun kassa avautuu.Kurssi lukittu 30 minuutiksi. Jokainen tuote on sinetöity, sen sarjanumero on tarkistettu, ja sillä on 24 kuukauden takuu.Sinetöity, 24 kuukauden takuu.
OWC
32 GB DDR4 2400 ECC registered DIMM for Cisco UCS B260 M4 and B460 M4 servers
This 32 GB DDR4 ECC registered DIMM is built for Cisco UCS B260 M4 E7 v4 and B460 M4 E7 v4 servers. It delivers error-correcting, registered memory for workloads that demand data integrity and uptime. It will not work in standard desktop PCs or with unbuffered and load-reduced modules.
The module runs at 1.2 V without a heat spreader, relying on server chassis airflow for cooling. Registered buffering and ECC logic add minimal overhead while maintaining signal integrity at 2400 MT/s. Power draw stays within JEDEC DDR4 limits for high-density server configurations.
The DIMM replaces Cisco part numbers HXMR1X322RVA, HXSPM32RVA, UCSMR1X322RVA, UCSMR1X322RVARF and UCSMR1X322RVAS. OWC provides a limited lifetime warranty with free technical support and an advanced replacement programme. Buyers needing unbuffered ECC or consumer desktop memory should choose a different product.
| Brand | OWC |
|---|---|
| Part Number | 2R4D42R432GB |
| Capacity | 32GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL17 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Heat Spreader | No |
| Compatible System | Cisco UCS B260 M4 E7 v4 Cisco UCS B460 M4 E7 v4 |
Tämän mallin muut versiot
Sama tuoteperhe, eri muisti, jäähdytin tai kellotaajuus — vertaile ennen päätöstä.
Power down the server, open the chassis, align the module notch with the slot key, press firmly until both retention clips click, then verify in BIOS that all 32GB are detected at 2400 MHz; the step most often missed is confirming the registered DIMM population order required by the B260 M4 memory riser guide.
No scheduled maintenance is required; the module has no heat spreader or moving parts. Replacement is only necessary if a memory diagnostic reports correctable ECC errors that exceed the platform threshold, at which point the single DIMM can be swapped without tools.
The memory controller’s maximum supported frequency of 2400 MHz is the first ceiling; the module cannot exceed its rated PC4-19200 speed, and the registered buffer adds one cycle of latency that becomes the bottleneck before voltage or thermal limits are reached.
Myös tällä osastolla
Sama osasto, sama kassa — kahdeksan kryptovaluuttaa ja 30 minuutin kurssilukko.
Valuutta, jolla maksetaan, sekä valuutta, jossa hinnat näytetään.
Lähetetään lompakostasi kassalla
Vain näyttöä varten — hinnat ovat Yhdysvaltain dollareissa
Valuuttaa ei löytynyt.
Valitse kieli, jolla sivusto puhuu sinulle.
Ei vastaavaa kieltä.
Uusi täällä?
Onko sinulla jo tili?
Automaattista palautusta ei ole: kauppa ei lähetä sähköpostia lainkaan, joten kertakäyttöistä linkkiä ei ole mistä pyytää. Jätä osoite tilille, niin se käsitellään käsin.
Pyyntö kirjattu
Mikään ei ole tulossa sähköpostiisi — tämä kauppa ei lähetä sähköpostia lainkaan. Joku käsittelee nämä pyynnöt käsin.
Muistitko sen?