LONGER
LONGER Laser Engraver Enclosure with Vent 27.5 x 27.5 x 13 inches
- Laser Engraver
69.99 $
0.00089733BTC
במלאי
LONGER
LONGER Ray5 10W Upgraded laser engraver 400×400mm 3.5" touchscreen
10 W laser engraves and cuts wood to 20 mm and acrylic to 30 mm across a 400 × 400 mm bed with a 0.06 mm spot and 24 000 mm/min speed
- Ultra-fine 0.06 mm spot for sharper detail
- Cuts 20 mm wood and 30 mm acrylic
- 400 × 400 mm bed handles large projects
- 24 000 mm/min top speed boosts output
- 5" touchscreen plus Wi-Fi, USB, TF card control
10 W laser engraver with 400 × 400 mm bed
The LONGER Ray5 is a 10 W diode laser engraver built around a 400 × 400 mm working area and a 3.5 inch colour touchscreen. It cuts 20 mm wood and 30 mm acrylic in a single pass and engraves with a 0.06 × 0.06 mm spot at up to 24 000 mm per minute. A 32-bit controller drives the motion system and handles Wi-Fi, USB, TF card and app connections for offline use.
Makers who need a large bed and simple controls
Hobbyists and small studios cutting thick wood or acrylic sheets will benefit from the generous bed and high optical power. The fixed-focus head removes manual focusing steps, and the touchscreen lets you start jobs without a computer. Users who require rotary engraving, air-assist integration or a fully enclosed cabinet should look at other platforms because those features are not included.
0.06 × 0.06 mm laser spot
The compressed laser spot measures 0.06 × 0.06 mm, which determines the finest detail the machine can reproduce. This spot size enables sharp text, clean vector lines and photo-grade dithering on wood, leather, acrylic and coated metal. If your workflow demands finer resolution than 0.06 mm, this engraver will not meet that requirement.
נקודות עיקריות
- Ultra-fine 0.06 mm spot for sharper detail
- Cuts 20 mm wood and 30 mm acrylic
- 400 × 400 mm bed handles large projects
- 24 000 mm/min top speed boosts output
- 5" touchscreen plus Wi-Fi, USB, TF card control
מפרט טכני
טרם פורסם מפרט טכני לפריט זה.
שאלות על הפריט הזה
Will the 400×400 mm bed on the Ray5 10W fit the clamps and honeycomb I already use with my smaller machine?
The working area is 400×400 mm; measure your existing clamps and honeycomb against those dimensions to confirm fit.
How can I confirm the 0.06×0.06 mm spot is performing correctly after setup?
Run a test grid in LaserGRBL or LightBurn and check that the 0.06 mm spot produces sharp, distinct lines at the 24000 mm/min maximum speed.
What comes in the box with the Ray5 10W and what must I source separately?
The engraver includes the 10W laser module, 3.5" touchscreen, 32-bit motherboard, Wi-Fi, USB, TF card slot and safety features; materials, air assist, rotary attachment and enclosure are sold separately.
גם במדף הזה
לקוחות השוו בין אלה
אותו מדף, אותה קופה — שמונה מטבעות קריפטו ונעילת שער ל-30 דקות.
