A-Tech 8GB DDR3 1333MHz PC3-10600 CL9 1.5V Desktop RAM

8GB DDR3 1333MHz Desktop Memory

This A-Tech module delivers 8GB of DDR3 memory at 1333MHz for desktop systems. It matches the PC3-10600 standard with CL9 latency and 1.5V operation. The unbuffered, non-ECC DIMM is built as a direct replacement for Corsair CMX8GX3M1A1333C9 and CMX16GX3M2A1333C9 kits.

Installing this 240-pin DIMM

Installation follows the standard desktop DIMM procedure: power down, open the case, align the notch, and press until the retention clips engage. The module uses standard 1.5V DDR3 voltage, so no BIOS voltage adjustment is required. Common issues arise when the motherboard does not support 8GB density per slot or expects a different CAS latency; verify the board's maximum module size and supported speeds before fitting.

PC3-10600 CL9 1.5V specification

The decisive specification is the PC3-10600 rating at CL9 with 1.5V operation. This defines the speed grade, timing, and voltage the memory controller must support. If the system requires a different voltage, a lower latency, or a higher or lower data rate, this module will not be compatible. Always cross-reference the motherboard's qualified vendor list or manual against these exact parameters.