BFKK 3U Rackmount Server Chassis EATX/ATX/MATX 4x5.25 6x3.5 Top/Side Cooling
- Rackmount
Brute Networks
16 GB DDR4-2133 ECC UDIMM with CL15 latency, 1.2 V operation and HP part 797259-091 compatibility for servers
This is a 16GB DDR4-2133 ECC unbuffered DIMM built with major-brand chips. It runs at PC4-17000 with CL15 latency and 1.20V. The module matches HP part 797259-091 and carries a lifetime warranty from Brute Networks.
This module fits HP systems that accept 288-pin DDR4 ECC UDIMMs at 2133 MT/s. It will not work in platforms that require registered or load-reduced DIMMs, nor in boards limited to non-ECC memory. Buyers needing higher densities or faster speeds must select a different module.
The dual-rank 2Rx8 layout determines whether the memory controller can address the full 16GB. Check the server documentation to confirm support for this rank configuration before ordering.
| Brand | HP |
|---|---|
| Capacity | 16GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Unregistered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
Align the notch on the 288-Pin DDR4 module with the slot key, press straight down until both side clips click, then verify the system reports 16GB at 2133 MT/s and ECC active.
No scheduled maintenance is required; the module carries a lifetime warranty and should only be replaced if memory diagnostics report uncorrectable errors or capacity needs change.
The JEDEC 1.20V voltage ceiling and CL15 timing at 2133 MT/s set the thermal and stability boundary before any higher frequency or lower latency profile can be applied.
同じ売り場の商品
同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。
お支払いに使うコインと、価格表示に使う通貨です。
チェックアウト時にウォレットから送信されます。
表示のみ—カタログの価格は米ドル建てです。
該当する通貨がありません。
サイトの表示言語を選択してください。
一致する言語がありません。
初めてのご利用ですか?
すでにお持ちですか?
自動的な再設定はありません。当店はメールを送信しないため、ワンタイムリンクをお送りすることもできません。アカウントにメールアドレスを残しておいていただければ、担当者が手作業で確認いたします。
リクエストを受け付けました
受信箱に何かが届くことはありません — 当店はメールを一切送信していません。担当者が手作業で確認いたします。
思い出しましたか?