EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
Micron Technology, Inc.
8GB DDR3L desktop memory module running at 1866 MT/s with CL13 latency and 1.35V operation
This Micron Technology desktop memory module provides 8GB of capacity at 1866MT/s with CL13 latency. It operates at the DDR3L standard voltage of 1.35V and uses an unbuffered, non-ECC design. The 2Rx8 chip organisation is built on Micron components.
This module fits desktop systems that specifically require DDR3L SODIMM or UDIMM memory running at 1.35V. It is not for builders needing ECC error correction or registered signal buffering. Buyers whose boards only accept standard 1.5V DDR3 should look elsewhere. Systems requiring higher density than 8GB per slot cannot use this part.
The single specification that decides fit is the 1.35V operating voltage. A motherboard must support the DDR3L standard to run this memory correctly. If the platform only supplies 1.5V to the memory slots, this module is not the right choice. Verify the board manual for DDR3L compatibility before purchase.
| Capacity | 8GB |
|---|---|
| Speed | DDR3L 1866 (PC3L 14900) |
| CAS Latency | CL13 |
| Voltage | 1.35V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Micron Chipset |
The module is sold as a single 8GB UDIMM; no additional brackets, cables or software are included.
Select this 1866MT/s CL13 stick if your motherboard supports DDR3L at that frequency; otherwise pick the speed your board specifies.
It provides a peak transfer rate of PC3L-14900 at 1.35V with CAS latency 13, giving standard DDR3L desktop bandwidth.
同じ売り場の商品
同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。
お支払いに使うコインと、価格表示に使う通貨です。
チェックアウト時にウォレットから送信されます。
表示のみ—カタログの価格は米ドル建てです。
該当する通貨がありません。
サイトの表示言語を選択してください。
初めてのご利用ですか?
すでにお持ちですか?
自動的な再設定はありません。当店はメールを送信しないため、ワンタイムリンクをお送りすることもできません。アカウントにメールアドレスを残しておいていただければ、担当者が手作業で確認いたします。
リクエストを受け付けました
受信箱に何かが届くことはありません — 当店はメールを一切送信していません。担当者が手作業で確認いたします。
思い出しましたか?