暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Two green circuit boards with black memory chips and gold edge connectors

NEMIX RAM

NEMIX RAM 64GB (2x32GB) DDR4 2933 CL21 1.2V 2Rx8 UDIMM Supermicro X12SCQ/ZF memory upgrade

SKU CH-XT41-52AVG

A 64 GB dual-channel kit of DDR4 2933 CL21 memory built for Supermicro X12SCQ and X12SCZ-QF motherboards

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR4 UDIMM
  • SpeedDDR4 2933 (PC4 23400)
  • CAS LatencyCL21
  • Voltage1.20V
  • ECCNo

Size 64GB 2X32GB

  • 64 GB capacity with two 32 GB modules for full system upgrade
  • DDR4 2933 speed rated at CL21 latency for responsive operation
  • 20 V low voltage reduces power draw and heat
  • 288-pin UDIMM form factor matches Supermicro X12SCQ and X12SCZ-QF slots
  • Built with Samsung Micron or Hynix chips and tested for stability

Exact-match DDR4 upgrade for Supermicro X12SCQ/ZF

This 64 GB kit contains two 32 GB unbuffered UDIMMs built to the DDR4 2933 (PC4-23400) standard. It is intended for owners of the Supermicro X12SCQ or X12SCZ-QF motherboards who need to reach the board's maximum supported capacity with modules the firmware will recognise immediately.

2Rx8 dual-rank organisation at CL21 1.2 V

Each module uses a 2Rx8 layout with CL21 timing and 1.2 V operation, the exact electrical profile the X12SCQ/ZF memory controller expects. Matching rank, voltage and latency is the single specification that determines whether the system will boot at the rated 2933 MT/s speed without down-clocking or instability.

Fills two 288-pin UDIMM slots with non-ECC memory

The kit occupies two DIMM sockets on the motherboard and provides non-ECC unbuffered DDR4, leaving any remaining slots free for future expansion within the board's population rules. It is not suitable for systems that require ECC registered modules, SODIMM form factors, or any memory standard other than DDR4.

特長

  • 64 GB capacity with two 32 GB modules for full system upgrade
  • DDR4 2933 speed rated at CL21 latency for responsive operation
  • 20 V low voltage reduces power draw and heat
  • 288-pin UDIMM form factor matches Supermicro X12SCQ and X12SCZ-QF slots
  • Built with Samsung Micron or Hynix chips and tested for stability

仕様

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR4 Non-ECC Unbuffered UDIMM Memory
Part NumberMD23400-328K2
Capacity64GB (2 x 32GB)
Type288-Pin DDR4 UDIMM
SpeedDDR4 2933 (PC4 23400)
CAS LatencyCL21
Voltage1.20V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR4 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content64GB 2X32GB DDR4 2933MHz PC4-23400 2Rx8 1.2V 288-PIN Non-ECC UDIMM KIT

このモデルの他のバージョン

同シリーズにさらに 5点

同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。

この商品に関する質問

Will the DDR4-2933 speed run at full 2933 MHz on my Supermicro X12SCQ board?

Yes, the kit is spec-matched to the motherboard's DDR4-2933 (PC4-23400) rating and its memory-population rules, so the controller recognises the full 64 GB at the rated frequency.

Does the PC4-23400 rating limit bandwidth compared to faster DDR4 modules?

PC4-23400 defines the maximum transfer rate at 2933 MT/s; the board's memory controller caps throughput at that level, so higher-speed modules would simply downclock to this speed.

Will the 288-pin UDIMM modules fit the DIMM slots on the X12SCZ-QF?

The 288-pin unbuffered UDIMM form factor is exactly what the X12SCQ and X12SCZ-QF require; no ECC, registered, or SODIMM modules will fit those slots.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。