暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Green bare circuit board DDR5 UDIMM memory module with black chips no heat spreader

NEMIX RAM

NEMIX RAM 8GB DDR5 5600 CL46 1Rx8 1.1V UDIMM Supermicro X13SAW-TLN4F memory upgrade

SKU CH-7ZGR-ZT02E

8GB DDR5 5600 module with CL46 timing and 1.1V operation, validated for the Supermicro X13SAW-TLN4F motherboard

  • Capacity8GB
  • Type288-Pin DDR5 UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCNo

Size 8GB

  • Exact 8GB DDR5-5600 upgrade for Supermicro X13SAW-TLN4F
  • 1Rx8 Non-ECC UDIMM at 1.1V CL46 matches board specs
  • Major OEM chips from Samsung, Micron or Hynix
  • 288-pin DDR5 form factor fits desktop motherboard slot
  • Lifetime replacement warranty with US-based technical support

Exact-match DDR5 upgrade

This 8 GB DDR5-5600 UDIMM is built for the Supermicro X13SAW-TLN4F motherboard. It uses the 288-pin unbuffered form factor that the board requires and carries the precise 1Rx8 rank structure the memory controller expects. The module installs as a direct replacement or capacity addition without configuration changes.

Standard JEDEC thermals

Operating at the standard 1.10 V DDR5 voltage, the module runs within normal thermal limits for unbuffered desktop memory. No heat spreader is fitted, relying on case airflow for passive cooling. Power draw stays at the baseline level defined by the DDR5-5600 specification during typical workloads.

CL46 latency at 5600 MT/s

The CAS latency of CL46 at the rated 5600 MT/s speed determines whether the module meets the board's timing requirements. Systems that need a different latency or voltage will not recognise this DIMM at its rated performance. Verify the motherboard's qualified-vendor list before purchase.

特長

  • Exact 8GB DDR5-5600 upgrade for Supermicro X13SAW-TLN4F
  • 1Rx8 Non-ECC UDIMM at 1.1V CL46 matches board specs
  • Major OEM chips from Samsung, Micron or Hynix
  • 288-pin DDR5 form factor fits desktop motherboard slot
  • Lifetime replacement warranty with US-based technical support

仕様

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-818K1
Capacity8GB
Type288-Pin DDR5 UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content8GB DDR5 5600MHz PC5-44800 1Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

このモデルの他のバージョン

同シリーズにさらに 5点

同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。

この商品に関する質問

How do I install this 288-pin DDR5 UDIMM in the Supermicro X13SAW-TLN4F and what step is often missed?

Align the notch on the module with the slot key, press down firmly until both retention clips click shut, then consult the motherboard manual for the approved DIMM population order so the system recognises the full 8 GB capacity.

What maintenance or replacement will this non-ECC UDIMM need over its service life?

No scheduled maintenance is required; the module has no heat spreader and runs at 1.1 V, so if a memory error appears years later the entire stick is simply replaced under the lifetime replacement warranty.

What limit appears first when this CL46 DDR5 5600 module runs under sustained load?

The fixed CAS latency of 46 cycles at 5600 MT/s sets the timing ceiling; without a heat spreader the DRAM temperature will rise until the memory controller throttles bandwidth to protect the chips.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。