暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Green printed circuit board with black memory chips on both sides, gold edge connector, no heat spreader

OWC

OWC 2R4D42R432GB 32GB DDR4 2400 CL17 1.2V 288pin ECC Registered RDIMM memory upgrade

SKU CH-RKDE-TJGMS

A 32 GB DDR4 2400 CL17 ECC registered RDIMM for Supermicro X10DR series motherboards

  • Capacity32GB
  • Type288-Pin DDR4 ECC RDIMM
  • SpeedDDR4 2400 (PC4 19200)
  • CAS LatencyCL17
  • Voltage1.2V
  • ECCYes
  • Server-grade reliability with ECC registered DDR4 technology
  • 32GB capacity extends memory headroom for virtualisation workloads
  • 2400MHz CL17 speed matches Supermicro X10DR series specifications
  • 2V operation reduces power draw in multi-DIMM configurations
  • Validated replacement for ten Supermicro MEM-DR432 part numbers

32GB ECC Registered DDR4 Module

This 32GB DDR4 2400MHz CL17 RDIMM is built for Supermicro X10DR series motherboards including X10DRFF-ITG, X10DRFR, X10DRG-H, X10DRH-C and X10DRFR-T. It delivers error-correcting registered memory for servers, workstations and NAS systems that require 288-pin ECC RDIMM modules.

Thermals and Power Draw

Operating at 1.2V, the module runs at standard DDR4 voltage without a heat spreader. Registered buffering reduces electrical load on the memory controller, helping maintain stable operation in multi-DIMM server configurations.

Build and Compatibility Notes

The 2Rx4 rank organisation and registered design mean this DIMM cannot be mixed with unbuffered memory and will not fit standard desktop platforms. It replaces multiple Supermicro part numbers such as MEM-DR432LC-ER24 and MEMDR432LCL01ER24 for direct upgrade paths.

特長

  • Server-grade reliability with ECC registered DDR4 technology
  • 32GB capacity extends memory headroom for virtualisation workloads
  • 2400MHz CL17 speed matches Supermicro X10DR series specifications
  • 2V operation reduces power draw in multi-DIMM configurations
  • Validated replacement for ten Supermicro MEM-DR432 part numbers

仕様

BrandOWC
Part Number2R4D42R432GB
Capacity32GB
Type288-Pin DDR4 ECC RDIMM
SpeedDDR4 2400 (PC4 19200)
CAS LatencyCL17
Voltage1.2V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
Heat SpreaderNo
Compatible SystemSupermicro Motherboard X10DRFF-ITG
Supermicro Motherboard X10DRFR
Supermicro Motherboard X10DRG-H
Supermicro Motherboard X10DRH-C
Supermicro Motherboard X10DRFR-T

このモデルの他のバージョン

同シリーズにさらに 5点

同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。

この商品に関する質問

How do I install this 288-pin DDR4 ECC RDIMM in a Supermicro X10DRG-H, and what step is often missed?

Power down the server, open the chassis, align the module key with the slot notch, press firmly until both latches click, then verify in BIOS that the 32GB capacity and 2400 MT/s speed are recognised; the step often missed is confirming the registered ECC type matches the board requirement and not mixing with unbuffered DIMMs.

What maintenance or replacement will this 32GB DDR4 2400 CL17 module need over its service life?

No scheduled maintenance is required; if a module fails it is replaced as a unit under the limited lifetime warranty, and the only ongoing care is keeping the server air filters clean so the 1.2V DIMMs stay within thermal limits.

What limit appears first when this 2Rx4 registered DIMM runs sustained workloads at 2400 MT/s?

The memory controller’s maximum supported capacity per channel and the 17-cycle CAS latency set the practical throughput ceiling before thermal throttling becomes a factor on these 1.2V modules.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。