Tripp Lite 9PX6KP1G2 6000VA 5400W 208/120V UPS

6 kVA Online UPS for Critical IT Loads

The Eaton 9PX G2 9PX6KP1G2 delivers 6000 VA and 5400 W of pure-sine-wave power through an online double-conversion topology. It accepts a wide 100–240 V AC input range and supplies selectable 120 V, 208 V, 200 V, 220 V, 230 V or 240 V output at 50 or 60 Hz. Eight outlets — six NEMA 5-20R, one L6-30R and one L14-30R — connect servers, storage and network gear in a 6U rack or tower form factor. A factory-installed NETWORK-M3 Gigabit card enables secure remote management.

Sustained Runtime and Thermal Behaviour

At full 5400 W load the internal valve-regulated lead-acid battery provides 3 minutes of backup; at half load the runtime extends to 8.30 minutes. Typical recharge completes in 3 hours. The unit operates continuously from 0 to 40 °C in 0–95 % non-condensing humidity. Online conversion isolates connected equipment from every input disturbance without switching delay, so voltage sags, surges and frequency drift never reach the load.

Replaces Standby or Line-Interactive Units

This UPS steps up from standby or line-interactive models that only condition power during anomalies. The jump is worth it when equipment cannot tolerate any transfer time, when harmonic distortion must stay below 3 %, or when remote shutdown and firmware updates over a hardened network card are required. It is not suited for installations that need longer battery autonomy without adding external packs, nor for sites limited to 120 V input-only wiring.