Computer Memory Solutions CM5126412800DIMM 8GB (2x4GB) DDR3 1600 CL11 1.5V memory upgrade

Compatible DDR3 Kit for ASRock 970 and B85 Boards

This 8 GB kit contains two 4 GB DDR3 modules built to run at 1600 MHz with CL11 timings. It is validated for ASRock 970 Pro2, B85 Pro4, B85iCafe4 and B85M Pro4 motherboards. The unbuffered non-ECC DIMMs install directly into standard 240-pin slots. Builders upgrading those specific platforms can add capacity without compatibility guesswork.

Steady Operation at 1.5 V Without Heat Spreaders

The modules operate at the standard 1.5 V DDR3 voltage and carry no heat spreaders, keeping the profile low for tight CPU cooler clearance. Under sustained workloads the chips run at their rated 11-11-11 timings without active cooling. Systems that load all four slots up to the board maximum of 32 GB will see consistent throughput because each stick uses a single 1Rx8 rank.

Low-Profile 240-Pin DIMMs for Everyday Builds

Each stick uses a standard 240-pin DDR3 edge connector and omits a heat spreader, so it fits beneath most tower coolers and in compact chassis. The two-module kit populates a pair of slots for dual-channel bandwidth on supported boards. Buyers needing ECC error correction or registered buffering for server-grade stability should look elsewhere, as this kit provides neither.