PrintOxe
PrintOxe PLA+ Pro 8-pack 1.75 mm 1 kg 3D printer filament
Eight 1 kg spools of 1.75 mm PLA+ filament in six colours, vacuum-sealed with desiccant and held to ±0.03 mm accuracy
- TypeFilament
- Eight colour spools in one box for project variety
- Vacuum sealed with desiccant to keep filament dry
- Dimensional accuracy of +/- .03 mm for consistent extrusion
- Made from 100 % new high-purity PLA+ for low warping
- Compatible with common 1.75 mm FDM printers
Multi-colour PLA+ bundle for FDM printers
This eight-spool set delivers 8 kg of 1.75 mm PLA+ filament in a curated palette: two black spools plus one each of white, light blue, bronze, green, fluorescent yellow and purple. Each spool is vacuum-sealed with desiccant to resist moisture uptake. The material is aimed at makers, educators and small-batch producers who want colour variety without ordering separate rolls.
Dimensional tolerance and printing behaviour
The filament holds a diameter tolerance of +/- .03 mm, promoting consistent extrusion and strong layer adhesion. The supplier states the formulation reduces shrinkage, warping, clogging and bubbling during normal printing. Spools measure 7.88 inch diameter, 2.69 inch width with a 2.20 inch hub hole, fitting standard 1.75 mm FDM machines from brands such as Creality, Prusa, Ultimaker and others listed.
Ready-to-use packaging and material claims
Every 1 kg spool arrives in its own sealed box, giving a total of 17.60 lbs of material that can be stored or distributed across projects. The manufacturer describes the resin as 100 % new high-purity, non-toxic and environmentally friendly, yielding a smooth surface finish. Note that on-screen colour representation may differ slightly from the physical filament.
주요 특징
- Eight colour spools in one box for project variety
- Vacuum sealed with desiccant to keep filament dry
- Dimensional accuracy of +/- .03 mm for consistent extrusion
- Made from 100 % new high-purity PLA+ for low warping
- Compatible with common 1.75 mm FDM printers
사양
| Brand | PrintOxe |
|---|---|
| Model | PLA+ / Pro PLA |
| Type | Filament |
이 상품에 대한 질문
How do I load the 1.75 mm spool onto my printer, and what step is often missed?
Mount the spool on the holder, thread the filament through the guide tube into the extruder, and pre-heat the hot end before pushing material through; skipping the pre-heat causes the drive gear to grind the filament.
What upkeep will the filament need after opening?
Store unused spools in the original vacuum-sealed bags with the included desiccant; if the material absorbs moisture, dry it at low heat before printing to prevent bubbles and poor layer adhesion.
What is the first limitation that appears during long prints?
Dimensional accuracy is held to ±0.03 mm, so extended runs may show slight diameter variation that can affect extrusion consistency on very large models.
이 진열대의 다른 상품
고객들이 함께 비교한 상품
같은 진열대, 같은 체크아웃 — 코인 8종, 환율 잠금 30분.
