Wij accepteren cryptovaluta — zo kunnen de munten die u bezit echte hardware kopen.Betaal in crypto, besteed het aan echte hardware. Gratis verzekerde verzending wereldwijd vanaf $399. Neutrale dozen zonder merk, verzonden vanuit Duitsland.Gratis verzekerde verzending vanaf $399. Uw koers wordt 30 minuten vastgezet zodra het afrekenen begint.Koers 30 minuten vastgezet. Elk artikel is verzegeld, het serienummer wordt gecontroleerd, en het valt onder 24 maanden garantie.Verzegeld, 24 maanden garantie.

Favoriete artikelen Inloggen
Green circuit board with a 24-pin ATX connector, eight 4-pin IDE and two 6-pin GPU power outputs

myVolts

myVolts ATX PSU Server Power Board 24Pin to 8x IDE 4Pin + 2x 6Pin

SKU CH-1XH4-NP3M0

Converts an ATX 24-pin supply into eight IDE and two 6-pin outputs for up to 30 hard drives

  • TypeAT
  • Converts one ATX 24‑pin connector into eight IDE 4‑pin and two GPU 6‑pin outputs
  • Delivers both 5 V and 12 V rails to power hard drives for mining rigs
  • Drive count scales with the PSU 5 V limit — 15 A supports up to 30 disks
  • Single board expands a desktop power supply for CHIA, ETH or BTC mining setups
  • Simple plug‑in design adds multiple drive connectors without extra power units

Adapter board for mining rigs

This adapter board connects to a desktop ATX power supply through a 24-pin input and provides eight 4-pin IDE connectors plus two 6-pin GPU connectors. It delivers 5 V and 12 V DC power for hard drives used in CHIA, ETH and BTC mining setups. The board is sold new and requires a separate ATX PSU to operate.

Suited for builders expanding drive counts

The board suits miners who need to run many IDE-powered drives from a single ATX unit; the number of drives supported depends on the 5 V current rating of the host supply. Builders whose power supply delivers less 5 V current than their planned drive array requires should look at a higher-rated ATX unit instead.

5 V current limit determines drive capacity

The key specification is the 5 V current upper limit of the ATX power supply, because each drive draws from that rail. If the supply outputs 15 A on 5 V, up to 30 drives can be connected, making this figure the deciding factor for whether the board meets the build’s needs.

Pluspunten

  • Converts one ATX 24‑pin connector into eight IDE 4‑pin and two GPU 6‑pin outputs
  • Delivers both 5 V and 12 V rails to power hard drives for mining rigs
  • Drive count scales with the PSU 5 V limit — 15 A supports up to 30 disks
  • Single board expands a desktop power supply for CHIA, ETH or BTC mining setups
  • Simple plug‑in design adds multiple drive connectors without extra power units

Specificaties

TypeAT

Vragen over dit artikel

What existing power supply is required to use this board?

You need a standard desktop ATX power supply with a 24-pin main connector to plug into the board's input.

Can I keep using my older IDE hard drives with this adapter?

Yes, the board provides eight IDE 4-pin connectors that deliver 5 V and 12 V power for those drives.

How do I verify the board is delivering power correctly after installation?

Check that your drives spin up and are detected by the system; the number you can run depends on your PSU's 5 V current limit (for example, 15 A supports about 30 drives).

Ook in deze afdeling

Klanten vergeleken ook

Dezelfde afdeling, dezelfde kassa — acht munten en een koers die 30 minuten vaststaat.