myVolts
myVolts ATX PSU Server Power Board 24Pin to 8x IDE 4Pin + 2x 6Pin
Converts an ATX 24-pin supply into eight IDE and two 6-pin outputs for up to 30 hard drives
- TypeAT
- Converts one ATX 24‑pin connector into eight IDE 4‑pin and two GPU 6‑pin outputs
- Delivers both 5 V and 12 V rails to power hard drives for mining rigs
- Drive count scales with the PSU 5 V limit — 15 A supports up to 30 disks
- Single board expands a desktop power supply for CHIA, ETH or BTC mining setups
- Simple plug‑in design adds multiple drive connectors without extra power units
Adapter board for mining rigs
This adapter board connects to a desktop ATX power supply through a 24-pin input and provides eight 4-pin IDE connectors plus two 6-pin GPU connectors. It delivers 5 V and 12 V DC power for hard drives used in CHIA, ETH and BTC mining setups. The board is sold new and requires a separate ATX PSU to operate.
Suited for builders expanding drive counts
The board suits miners who need to run many IDE-powered drives from a single ATX unit; the number of drives supported depends on the 5 V current rating of the host supply. Builders whose power supply delivers less 5 V current than their planned drive array requires should look at a higher-rated ATX unit instead.
5 V current limit determines drive capacity
The key specification is the 5 V current upper limit of the ATX power supply, because each drive draws from that rail. If the supply outputs 15 A on 5 V, up to 30 drives can be connected, making this figure the deciding factor for whether the board meets the build’s needs.
주요 특징
- Converts one ATX 24‑pin connector into eight IDE 4‑pin and two GPU 6‑pin outputs
- Delivers both 5 V and 12 V rails to power hard drives for mining rigs
- Drive count scales with the PSU 5 V limit — 15 A supports up to 30 disks
- Single board expands a desktop power supply for CHIA, ETH or BTC mining setups
- Simple plug‑in design adds multiple drive connectors without extra power units
사양
| Type | AT |
|---|
이 상품에 대한 질문
What existing power supply is required to use this board?
You need a standard desktop ATX power supply with a 24-pin main connector to plug into the board's input.
Can I keep using my older IDE hard drives with this adapter?
Yes, the board provides eight IDE 4-pin connectors that deliver 5 V and 12 V power for those drives.
How do I verify the board is delivering power correctly after installation?
Check that your drives spin up and are detected by the system; the number you can run depends on your PSU's 5 V current limit (for example, 15 A supports about 30 drives).
이 진열대의 다른 상품
고객들이 함께 비교한 상품
같은 진열대, 같은 체크아웃 — 코인 8종, 환율 잠금 30분.



