Vszerda
Vszerda M.2 M-Key & B-Key SATA Adapter internal SSD
Dual-slot adapter connects M-key and B-key SATA SSDs simultaneously with driver-free setup and up to 6.0 GB/s throughput
- Supports both M-key and B-key drives simultaneously
- Driver-free installation gets you running immediately
- Data transfers up to 6.0 GB/s over SATA
- Tantalum capacitors and a power inductor stabilise the signal
- Dual 12 V and 3.3 V rails deliver steady power
Vszerda M.2 Dual-Key SATA Adapter
This adapter card fits one M-key and one B-key M.2 SATA SSD simultaneously. It connects each drive to the host through a SATA interface using a PCI-Express 2.0 x4 slot. No driver installation is required on supported operating systems.
Suits builders adding two SATA M.2 drives
The card is designed for SATA-based M.2 modules only. It will not operate with drives that use a different protocol, so buyers needing that capability should look elsewhere. The dual-voltage supply delivers 12 V and 3.3 V through quality tantalum capacitors and a power inductor.
PCI-Express 2.0 x4 host interface
The slot provides the electrical link for both M.2 sockets and caps the combined throughput at 6.0 GB/s. Verify that your motherboard has a free PCI-Express 2.0 x4 slot and that your M.2 drives are SATA models with the correct keying.
Najważniejsze cechy
- Supports both M-key and B-key drives simultaneously
- Driver-free installation gets you running immediately
- Data transfers up to 6.0 GB/s over SATA
- Tantalum capacitors and a power inductor stabilise the signal
- Dual 12 V and 3.3 V rails deliver steady power
Specyfikacja
Na razie brak opublikowanej specyfikacji tego produktu.
Pytania dotyczące tego produktu
Does the adapter draw power from both 12V and 3.3V rails while running all day?
Yes, it uses a dual-voltage design that supplies both 12V and 3.3V through high-quality tantalum capacitors and a power inductor for stable operation.
Must my motherboard provide an M.2 slot wired for SATA rather than PCIe?
The card accepts both M-key and B-key M.2 modules simultaneously and connects them to a standard SATA interface, so the host slot must carry SATA signals.
Will a legacy SATA-II controller limit the 6.0 GB/s transfer rate advertised?
The adapter supports up to 6.0 GB/s, but actual throughput will match the speed of the SATA controller and drive installed.
Także w tym dziale
Klienci porównywali też te produkty
Ten sam dział, ta sama kasa — osiem kryptowalut i 30-minutowa blokada kursu.
