We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green PCB adapter board with M-key and B-key M.2 slots and SATA connector

Vszerda

Vszerda M.2 M-Key & B-Key SATA Adapter internal SSD

SKU CH-18WQ-BD7YE

Dual-slot adapter connects M-key and B-key SATA SSDs simultaneously with driver-free setup and up to 6.0 GB/s throughput

  • Supports both M-key and B-key drives simultaneously
  • Driver-free installation gets you running immediately
  • Data transfers up to 6.0 GB/s over SATA
  • Tantalum capacitors and a power inductor stabilise the signal
  • Dual 12 V and 3.3 V rails deliver steady power

Vszerda M.2 Dual-Key SATA Adapter

This adapter card fits one M-key and one B-key M.2 SATA SSD simultaneously. It connects each drive to the host through a SATA interface using a PCI-Express 2.0 x4 slot. No driver installation is required on supported operating systems.

Suits builders adding two SATA M.2 drives

The card is designed for SATA-based M.2 modules only. It will not operate with drives that use a different protocol, so buyers needing that capability should look elsewhere. The dual-voltage supply delivers 12 V and 3.3 V through quality tantalum capacitors and a power inductor.

PCI-Express 2.0 x4 host interface

The slot provides the electrical link for both M.2 sockets and caps the combined throughput at 6.0 GB/s. Verify that your motherboard has a free PCI-Express 2.0 x4 slot and that your M.2 drives are SATA models with the correct keying.

Highlights

  • Supports both M-key and B-key drives simultaneously
  • Driver-free installation gets you running immediately
  • Data transfers up to 6.0 GB/s over SATA
  • Tantalum capacitors and a power inductor stabilise the signal
  • Dual 12 V and 3.3 V rails deliver steady power

Specifications

No published specifications for this item yet.

Questions about this item

Does the adapter draw power from both 12V and 3.3V rails while running all day?

Yes, it uses a dual-voltage design that supplies both 12V and 3.3V through high-quality tantalum capacitors and a power inductor for stable operation.

Must my motherboard provide an M.2 slot wired for SATA rather than PCIe?

The card accepts both M-key and B-key M.2 modules simultaneously and connects them to a standard SATA interface, so the host slot must carry SATA signals.

Will a legacy SATA-II controller limit the 6.0 GB/s transfer rate advertised?

The adapter supports up to 6.0 GB/s, but actual throughput will match the speed of the SATA controller and drive installed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.